good luck....My install of mandrake 10 commercial was a breeze....all the hardware on the A7V8X recognised first time.
However there does seem to be an issue using the board with a Hauppague pvr 350 - get a total system lock when I try and tune any channels (under both MK 10 & Win XP Pro)... On Saturday 31 Jul 2004 09:00, Lee Wiggers wrote: > On Sat, 31 Jul 2004 12:06:30 +0100 > > Phil <[EMAIL PROTECTED]> wrote: > > What's the output of "lspci"? Does it show a Broadcom ethernet > > device? Yes > > Also watch when the system boots. On first boot before the > > bootloader you should see a screen listing the devices on the pci > > bus. There should be a network contoler listed with its interupt > > (IRQ). > > > > If you don't see a network controller then it may be disabled, > > check the cmos setup to ensure it is enabled (on my A7V8X it can > > not be disabled in the setup). > > > > do you run windows (ugh), if so, does the ethernet controller > > work? > > Yep, ran win2k for over a year before a bad fan fried the cpu last > weekend. I just replaced the cpu with a 2.7g screamer and put a > real operating system on the drive. > > I'm dl'ing 10 community now. The driver was discussed in cooker a > while back, so it's probably in there. That's just as easy as > installing a floppy in the computer. > > Lee
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________
