I didn't try it, I would try it this night, thanks :) flupke wrote: > > On Mon, 12 Jun 2000, iagoba wrote: > > > Hi to all, > > > > First of all, I want to say Hi to all the people in this list, this is > > my first mail, and hope you can help me. > > > > I got some problems with my Clonic Ethernet card, I Installed Mandrake > > 7.0-2 in my computer, in a second partition of 3 GB, (I got Windows 98 > > in the other partition), my computer got this characteristics: > > > > AMD K6-2 500 Mhz. > > 128 MB Ram > > RIVA TNT 2 M64 > > 13.0 Gb. HD > > Clonic Ethernet Card 10/100 MB ne2000 compatible. > > CD-ROM 48x > > > > My Ethernet Card is ISA, 16 bits and PnP, Linux Detect it, but in a > > different I/O address and different IRQ, when I put the correct I/O > > address (240h), and IRQ (11), when I re-initiate my computer, it says > > "Bringing eth0 ................... [OK]" > > but here it finish to initiate Linux, don't loading it and don't making > > Anything, what could be the problem? when I change that I/O or IRQ, it > > says "Bringing eth0 ................. [FAILED]" but initiates Linux, > > (without working the eth0 of course). > > > > Hope you could help me. > > Iagoba > > Does it work if you boot with the wrong nic settings and then load the > module with the right parameters? (insmod ne io=0x330). > > I also heard about some ISA nics that had to be initialized with a DOS > program provided with the drivers before beeing able to work. If this is > your case, you'll have to boot in DOS, run the program, and then boot > linux with loadlin. > > HTH > Flupke > > -- > << There's no place like ~ ! >>