Thanks to Matt and Mike. I will try to do what you both suggested.
jf
> From: "Matt Schroeder" <[EMAIL PROTECTED]>
> Reply-To: [EMAIL PROTECTED]
> Date: Fri, 19 Jan 2001 14:20:10 -0600
> To: <[EMAIL PROTECTED]>
> Subject: Re: [newbie] Two little problems
>
> I had a problem using the CUPS printer setup. It worked for the test but
> after that it never would work. Try plain LP0.
>
> I also have an external modem on Com1 and used KPPP to get it going. Open
> it and I think under modem you pick /dev/ttyS0 for COM1
>
> Then query it and it should identify itself to the dialup program.
>
> This is all new to me but it worked...
>
> Good luck,
>
> --Matt
>> Question 2. My computer came with a winmodem installed but I have an
>> external USR modem that I connected to one of the ports on the back (COMM1).
>> The problem is that ML7.2 does not know there is a modem connected (checked
>> Hardrake and there is nothing there, no modem is seen). How do I make sure
>> the ML knows there is a modem attached?
> ============================
> Are you trying to connect using kppp? If so, in setup set the device as ttyS0
> (corresponds to Windows Com1).
> Mike
