What error message do you get?
On Tue, 27 Feb 2001, you wrote:
> Damn me if it hasn't stopped again. Any suggestions?
>
> regards
>
> Daryl
>
> > -----Original Message-----
> > From: [EMAIL PROTECTED]
> > [mailto:[EMAIL PROTECTED]]On Behalf Of Daryl Johnson
> > Sent: 27 February 2001 21:13
> > To: [EMAIL PROTECTED]
> > Subject: RE: [newbie] Adaptec SCSI Installation AVA 1505
> >
> >
> > At Last!
> >
> > I found a doc which suggested that the silk screening of the
> > jumpers on the
> > board was faulty but use the diagram instead in the online manual
> > available
> > on the Adaptec site.
> >
> > I checked and found that I WAS using the correct jumper for IRQ 9
> > and also
> > port 0x140, neither of which were causing conflicts in the tables.
> >
> > On a whim I jumpered the board top use port 0x340 and tried the insmod
> > command
> >
> > insmod aha152x aha152x=0x340,9,7,1,1,0,500,0
> >
> > and the board loaded! <scenes of riotous joy>
> >
> > All I have to do now is find out which tape device in /dev my Colorado
> > likes. Sheesh.
> >
> > Thanks Mark
> >
> > regards
> >
> > Daryl
> >
> > > -----Original Message-----
> > > From: [EMAIL PROTECTED]
> > > [mailto:[EMAIL PROTECTED]]On Behalf Of mark
> > > Sent: 22 February 2001 02:12
> > > To: [EMAIL PROTECTED]
> > > Subject: Re: [newbie] Adaptec SCSI Installation AVA 1505
> > >
> > >
> > > Try this:
> > >
> > > insmod aha152x aha152x=0x140,9,7,1,1,0,500,0
> > >
> > > Don't ask me what it all means, but it works on this card.
> > >
> > > [...]
> >
> >
> >
--
*******************************
fairlane at voyager dot net
www.geocities.com/dieseltempo
*******************************
