Damn me if it hasn't stopped again. Any suggestions?
regards
Daryl
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Daryl Johnson
> Sent: 27 February 2001 21:13
> To: [EMAIL PROTECTED]
> Subject: RE: [newbie] Adaptec SCSI Installation AVA 1505
>
>
> At Last!
>
> I found a doc which suggested that the silk screening of the
> jumpers on the
> board was faulty but use the diagram instead in the online manual
> available
> on the Adaptec site.
>
> I checked and found that I WAS using the correct jumper for IRQ 9
> and also
> port 0x140, neither of which were causing conflicts in the tables.
>
> On a whim I jumpered the board top use port 0x340 and tried the insmod
> command
>
> insmod aha152x aha152x=0x340,9,7,1,1,0,500,0
>
> and the board loaded! <scenes of riotous joy>
>
> All I have to do now is find out which tape device in /dev my Colorado
> likes. Sheesh.
>
> Thanks Mark
>
> regards
>
> Daryl
>
> > -----Original Message-----
> > From: [EMAIL PROTECTED]
> > [mailto:[EMAIL PROTECTED]]On Behalf Of mark
> > Sent: 22 February 2001 02:12
> > To: [EMAIL PROTECTED]
> > Subject: Re: [newbie] Adaptec SCSI Installation AVA 1505
> >
> >
> > Try this:
> >
> > insmod aha152x aha152x=0x140,9,7,1,1,0,500,0
> >
> > Don't ask me what it all means, but it works on this card.
> >
> > [...]
>
>
>
