If you do really understand how it works, then go ahead and turn the crankshaft 
(by hand, slowly) and watch what happens. There will be a place in rotation (do 
it many times) where the cam chain will be quite slack. The tension on it 
changes during rotation. Rotating the crankshaft backwards may show the slack 
spot more easily.  There was an update tensioner for '83  models. All new parts 
supersede to the update. I would replace with the new part and not attempt a 
repair of the original. It's a bear of a job but can be done without making a 
real mess of the motor. Leave the cylinder head on. Unless, of course you're 
replacing the cam chain too. You have the OEM manual ?  Good instructions for 
removal. The tensioner must be unloaded to be removed. The manual does not 
address the dynamic of changing tensions during running. The failed tensioner 
is not controlling the chain during a lightly loaded situation. The spring 
isn't strong enough to work
 properly. All these things are cured with the update. 

--- On Sat, 8/22/09, oldschoolgwin <[email protected]> wrote:

From: oldschoolgwin <[email protected]>
Subject: [Nighthawk Lovers] NH650 - Automatic cam chain tensioner inspection 
findings.
To: "Nighthawk Motorcycle Lovers!" <[email protected]>
Date: Saturday, August 22, 2009, 8:35 PM


Hi All,

Well my 83 650 with 43K miles is rattling like a paint can at 2800 to
3300 rpm so it's time to deal with the automatic cam chain tensioner
(or lack there of).

I've studied all that the Honda OEM manual has to offer on this
mechanism - so I know the pricipals by which it works but not any
inspection criteria.

I pulled the valve cover and this what i find:

1) No marks on the valve cover chain guard.
2) The cam chain was taught between the cam gears - I could push it
1/8" (total range of motion) when applying ~ 5 lbs downward and upward
to the chain in between the gears, and the chain would retain whatever
tension it had.
3) I pushed on the chain (same as in (3) above) with about 20 lbs and
then it went slack with about 1/4" total range of motion up and down.
I turned the engine 1/4 crank or so with the back wheel and the chain
went back to the original tension as in (2)
4) The spring is connected to the mechanism (taught)

That's about all I've observed at this stage.

My question is: I
Is there a definate way to diagnose the health of the tensioning
system?
Would the chain behaviour in (2) and (3) above be expected for a
tensioner in good shape?
Is there anything else i should inspect now before removal of the
cams)
How should a healthy tensioner behave during inspection?

I was actually hoping I would find the tensioner arm magically
"unstick" if i wiggled it but that may be a bit of a optimistic dream
- right!

Thanks for any suggestions you have.

Paul






      
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"Nighthawk Motorcycle Lovers!" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/nighthawk_lovers?hl=en
-~----------~----~----~----~------~----~------~--~---

Reply via email to