On 20/09/13 14:53, Thomas Schmid wrote: > > The binary I sent above still bricks my oocd connections. I am not > 100% sure why, but I believe that it reconfigures the reset GPIO line > to be a regular output pin and pulls it low. > I managed to get my device into a similar state to the one that Thomas reports this morning. I had not made any changes to my code since it was working fine yesterday evening. First attempt to flash the part started reporting Read Errors and from there I couldn't reconnect.
Symptoms as follows: - Debugger disconnected - RST line is low for ~50us then goes high and low again after a few us. This could be a very short WDOG timeout? - With debugger connected, RST line cycles with quite slow rise and fall times over around a 100us period between 1.0V and 1.5V. - oocd reports garbage number of breakpoints and lots of read/write errors. I realise this isn't very useful information for debugging the problem but thought I'd record it anyway! I need to get on with development so have taken a trip to Windows 8 to use MSD to reflash the part and can now connect fine. Chris ------------------------------------------------------------------------------ October Webinars: Code for Performance Free Intel webinars can help you accelerate application performance. Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from the latest Intel processors and coprocessors. See abstracts and register > http://pubads.g.doubleclick.net/gampad/clk?id=60133471&iu=/4140/ostg.clktrk _______________________________________________ OpenOCD-devel mailing list OpenOCD-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/openocd-devel
