You're welcome Michael, glad to hear that it was finally resolved for you. We have all been in almost the same or similar situations at one time, so we are just paying back the favors to others.
Sincerely, Brad Velander Senior PCB Designer Northern Airborne Technology #14 - 1925 Kirschner Road, Kelowna, BC, V1Y 4N7. tel (250) 763-2329 ext. 225 fax (250) 762-3374 -----Original Message----- From: Robison, Michael R NAVSEA [mailto:[EMAIL PROTECTED] Sent: Wednesday, November 30, 2005 1:28 PM To: Protel EDA Discussion List Subject: RE: [PEDA] Components not transferring to PCB Yes! It worked! Thank you for all the help! There were several suggestions that would have done the trick, but I used the one where I updated the board, moved the chips onto it, selected everything outside the board and deleted it, and then updated it again. I had to go through that process three or four times before I retrieved all the chips. I'm now anxious to get the components placed nicely, autoroute it with some acceptable design rules, and generate the Gerbers. More than once I've run into trouble getting the Gerbers produced, so I'm anxious to get over that hurdle, too. Again, I would like to thank everybody that posted on my problem. It was very kind and generous of you. Thanks, Michael ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
