Morning Dennis,
Gee, great minds think alike.
I guess the schematic problem you mention is the same one that I
mentioned, where the split jumps to 1/2 way across the right monitor when you
just click along a vertical axis 3/4 across the right monitor?
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2232 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Dennis Saputelli [mailto:[EMAIL PROTECTED]
Sent: Wednesday, June 21, 2006 9:01 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] Mouse Scroll Wheel in Protel 99SE/Dual Screens
ooooh ...
major potential issues with that
esp re loaded libraries
i have had so much trouble with that (running 2 instances of P99SE) that
whenever it happens by mistake i shut down BOTH and then start up 1 again
i have absolutely found this required, but i can't remember all the
details of why
i use dual monitors w/ 99SE
i have a lot of trouble when the schematic is spread across 2 screens
when i click on the right screen it gets confused
PCB seems ok
sch on one screen, pcb on the other seem ok
ds
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
