this sounds about consistent with what brad & i have said brad, i didn't notice it (sch issue) as closely as you did but putting the sch on one monitor solved the issue, too bad
AD6 doesn't do this and am also playing with manual routing, it seems pretty good and smart at that but i am nowhere up to speed on the program ds _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com Robert Mitchell wrote: > Brad Velander wrote: > I also use 2 screens but do not attempt to have 99SE fill the whole space. > I place the working area, eg, the schematic on one screen and the other > panel on the second screen so that the split lies along the join between > the two sections of the work area. I have moved the tool bars into that > area as well so that the schematic, itself is as big as possible within > the confines of a 20" monitor. This leaves an amount of working area on > the other screen which I use for pdf datasheets, email and anything else > I might want to use while working on a Protel projec. > I find that this works well for me. > > Bob Mitchell > > > > --- > avast! Antivirus: Outbound message clean. > Virus Database (VPS): 0625-5, 21/06/2006 > Tested on: 22/06/2006 11:44:14 AM > avast! - copyright (c) 1988-2006 ALWIL Software. > http://www.avast.com > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
