Well, assume that AD6 is far away from horizon of my possibilities... :) I have put 20x Symbols to main schema and changed symbols' names and now the problem is to generate appropriate netlist and then user my pre-made PCB. Is that possible?
Dennis Saputelli napisał(a): > GET AD6 > :) > it really handles this pretty well > > in 99SE there are methods but at the end of the day i found that you > really needed the 20 separate sheets > and getting them to all annotate nicely was a major pain > > the 'repeat' feature was what finally drove me to AD6 > > Dennis Saputelli > > > _______________________________________________________________________ > CONTACT INFORMATION: > _______________________________________________________________________ > Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 > 2851 21st Street Fax: 415-647-3003 > San Francisco, CA 94110 www.integratedcontrolsinc.com > _______________________________________________________________________ > NOTE! TO PASS OUR SPAM FILTER PUT THE FOLLOWING IN SUBJECT LINE: I.C.I. > > > Jakub M. wrote: > >> [PROTEL 99 SE] >> >> In a device I want to put about 20 similar channels. Therefore I have >> made a schema of a channel and have put it to main schema as a Sheet >> Symbol 20 times. I have also made PCB for the single channel. >> >> Question: >> >> I want to generate netlist for the whole device and to use already made >> PCB of channel (the same for all channels). How to do this? >> >> >> Regadrs, >> JM >> >> >> >> ____________________________________________________________ >> You are subscribed to the PEDA discussion forum >> >> To Post messages: >> mailto:[email protected] >> >> Unsubscribe and Other Options: >> http://techservinc.com/mailman/listinfo/peda_techservinc.com >> >> Browse or Search Old Archives (2001-2004): >> http://www.mail-archive.com/[email protected] >> >> Browse or Search Current Archives (2004-Current): >> http://www.mail-archive.com/[email protected] >> >> >> > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
