as far as i know, no because the symbols would all point to the same file name
i think there is a method in 99SE for it to auto generate all the sheets from the first one but frankly i can't remember for sure, should be in the docs i guess the problem i remember is that corresponding parts in each repeated section were not annotated logically Dennis Saputelli _______________________________________________________________________ CONTACT INFORMATION: _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com _______________________________________________________________________ NOTE! TO PASS OUR SPAM FILTER PUT THE FOLLOWING IN SUBJECT LINE: I.C.I. Jakub M. wrote: > Well, assume that AD6 is far away from horizon of my possibilities... :) > > I have put 20x Symbols to main schema and changed symbols' names and now > the problem is to generate appropriate netlist and then user my pre-made > PCB. Is that possible? > > > Dennis Saputelli napisał(a): > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
