AH YES 'flatten' was the term i had forgotten
Dennis Saputelli _______________________________________________________________________ CONTACT INFORMATION: _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com _______________________________________________________________________ NOTE! TO PASS OUR SPAM FILTER PUT THE FOLLOWING IN SUBJECT LINE: I.C.I. Jon Elson wrote: > > Dennis Saputelli wrote: > > That is the flatten hierarchy. If you set up the component designators > in a certain > way, you can then use simple global editing macros to set all component > designators > to be unique for each sheet after flattening. So, that Cxx01 becomes > C1201 on sheet > 12, for instance. > > Jon > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
