Hugh, I have one at my guest cabin doing the same thing except that the meter on the mate says I have 119 vac but nothing at the AC Out terminal. I think Kent might be right that it may be the AC output relay. It is odd though that there is no error message in your case. This inverter had been tortured by the last tenants of the cabin with bad generators. I was actually going to go up there and check it out some more as it is warm today. No heat in the cabin.
John Blittersdorf On Mon, Mar 9, 2020 at 1:00 PM Kent Osterberg <k...@coveoregon.com> wrote: > Hugh, > > I've seen these symptoms before. The problem was a failed output relay on > the ac board. > > Kent Osterberg > Blue Mountain Solar > > > On 3/9/2020 9:25 AM, Hugh Piggott wrote: > > Hi Wrenches, > > I wonder if anyone can tell me what is happening here? > > I have an Outback VFX that I used for my own home from 2006-2018. It’s a > 50Hz 240V unit, but similar otherwise to any other 48V VFX. It was working > well when disconnected. I needed to replace the inverter system for other > reasons. > > I installed this for a neighbour recently on his 48V system, and it > apparently worked when I left the building. > > Now it’s not working. When “off” it shows a warning for temperatures > sensor - fair enough I did not install one. Maybe when it gets connected > to a generator it will be found a sensor. This is the only error or fault > with a yes. > > When “on” it makes a reassuring buzz and both lights come up green and > there is no error or warning in the Mate. Just one problem - no output. > > Another weird thing. I go to the status menu and check meters > STATUS/FX/METER output voltage and it says “4V”. So it *knows* that it > is not working but it appears to have no qualms or misgivings about this > state of affairs. NO error, no warning, two green lights. > > I tried rebooting with the battery fuse. I tried resetting to factory > defaults. No joy. > > I suppose I will take it to pieces and try to figure out a hardware > failure but I wonder if anyone has seen this and can give me a clue? > > cheers > Hugh > > > Hugh Piggott > Scoraig Wind Electric > Dundonnell > Ross shire > IV23 2RE, UK > +44 77 1315 7600 > h...@scoraigwind.co.uk > www.scoraigwind.co.uk > > > > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & > settings:http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette:www.re-wrenches.org/etiquette.htm > > Check out or update participant bios:www.members.re-wrenches.org > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > >
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
