Has anyone used HO cork as roadbed, leaving a gap in the middle?  Have 
you had any problems?  I have some extra HO cork roadbed from my earlier 
HO days which I could use under, for example, SHS flextrack.
tx for info in advance
Rance Velapoldi

Chuck Smith wrote:

>Based on your time crunch, I see 2 options:
>1) Use 1/2 piece HO and 1/2 piece cork together. Staple in place if you
>want to move it later.  Ideally paint roadbed gray, assuming you don't
>want to make it permanent by ballasting. Then drill a hole about every
>foot in a tie and use the brads to hold the track. Cork roadbed is
>available at any reasonably well stocked train store.  If you can only
>get HO roadbed then you need to cut an additional strip that fills in
>the center.
>
>2) Don't use roadbed at all and go with your dark headed brad idea. 
>Again, place one about every food or, if you're using sectional track,
>one at one side of every joint.  Drill the tiny hole the brad needs to
>avoid damaging the track.
>  
>



S-Trains list sponsor: http://www.americanflyertrains.com
All the Flyer you desire...books and accessories too!

To UNSUBSCRIBE from this list send a note to [EMAIL PROTECTED] 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ 


Reply via email to