I used some for a section at the back of my layout where it couldn't be
seen from above.  Worked there with no problems for years.

Rance and Bente Velapoldi wrote:
> 
> Has anyone used HO cork as roadbed, leaving a gap in the middle?  Have
> you had any problems?  I have some extra HO cork roadbed from my earlier
> HO days which I could use under, for example, SHS flextrack.
> tx for info in advance
> Rance Velapoldi
> 
> Chuck Smith wrote:
> 
> >Based on your time crunch, I see 2 options:
> >1) Use 1/2 piece HO and 1/2 piece cork together. Staple in place if you
> >want to move it later.  Ideally paint roadbed gray, assuming you don't
> >want to make it permanent by ballasting. Then drill a hole about every
> >foot in a tie and use the brads to hold the track. Cork roadbed is
> >available at any reasonably well stocked train store.  If you can only
> >get HO roadbed then you need to cut an additional strip that fills in
> >the center.
> >
> >2) Don't use roadbed at all and go with your dark headed brad idea.
> >Again, place one about every food or, if you're using sectional track,
> >one at one side of every joint.  Drill the tiny hole the brad needs to
> >avoid damaging the track.
> >
> >

-- 
Chuck Smith of the NASG, Rochester Area S Gaugers (RASG) 
and the S Gauge Chemung Valley Lines. http://home.eznet.net/~cesmith

"It is often wiser to remain silent and be thought a fool
than to speak up and remove all doubt." Mark Twain

S-Trains list sponsor: http://www.americanflyertrains.com
All the Flyer you desire...books and accessories too!

To UNSUBSCRIBE from this list send a note to [EMAIL PROTECTED] 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ 


Reply via email to