Triode wrote:
> Sorry if it doesn't support USB audio class 1 or 2 then and does not
> work with the standard linux drivers then it won't work with touch.
This is the reply from Nuforce support:
Dear Customer,
Yes, the DAC-9 supports USB audio class 2. Anything greater than 96kHz
is class 2, a
Now that Logitech is no longer developing or selling the Squeezebox
line, including Touch --- does this mean this code development is done
too? Did you have plans for any further enhancements, that are now
altered because of these market events? What are your thoughts on
logitech pulling the pl
shkorc wrote:
> I see. If it does not support UAC2 standard, are there any other options
> to try?
Sorry if it doesn't support USB audio class 1 or 2 then and does not
work with the standard linux drivers then it won't work with touch.
--
I see. If it does not support UAC2 standard, are there any other options
to try?
shkorc's Profile: http://forums.slimdevices.com/member.php?userid=57025
View this thread: http://forums.slimdevices.com/showthread.php?t=94512
shkorc wrote:
> I can confirm EDO is working with an Audio-Gd 15.1 (TE8802L chip)
> DAC/headphone amp using Kernel#11, thank you Triode for that!
>
> I then reset the Touch to factory defaults and applied the original
> kernel to try with my second DAC the Nuforce DAC-9. I repeated the setup
> s
I can confirm EDO is working with an Audio-Gd 15.1 (TE8802L chip)
DAC/headphone amp using Kernel#11, thank you Triode for that!
I then reset the Touch to factory defaults and applied the original
kernel to try with my second DAC the Nuforce DAC-9. I repeated the setup
steps like with the 15.1, ex
I've had mine for 2 years (since the SB Touch was released). I've used
it regularly, but turn off the power to the entire rig when not in use.
I know this is a controversial topic. Some people say the turn on/off
cycles are hard on electronics, but I am not sure if it is the case with
the Touuch.
Triode wrote:
> Afraid that's not possible at present as the Touch digital output is
> always active. It would require changes to the main touch firmware to
> signal that it is off (unlikely).
Is the touch firmware in open source so one can mess with it? So there
is no way to hook up to the po
Kuro wrote:
> Hi Triode,
>
> I just got this battery powered Legato II. The USB side is running
> StreamLength USB code by Gordon Rankin.
>
> It works great with EDO, but in order for it to go into charging mode
> when not playing music, SBT must tell it that music is not streaming.
> Or if U
I just received a second Touch from Amazon today - brand new, all
sealed. $249.
cjfreitag's Profile: http://forums.slimdevices.com/member.php?userid=41363
View this thread: http://forums.slimdevices.com/showthread.php?t=964
I ripped all my CDs usin WAV lossles and the hard drives on my SBT and
Sony blu-ray are both back up copies of my original hard drive so the
music files are exactly the same on all the drives.
My pc i built for gaming Intel Core i7-2600K , Asus P8P67 PRO Intel
P67,Corsair Vengeance 8GB (2x4GB)
S
Monzaboy wrote:
> I run the SBT through digi out into my Cyrus dacX + psxr then the dac
> goes into my Glasshouse passive preamp then to my mono block amps.The
> volume on the SBT is and always has been set to 100% ive never tried or
> used the analogue rca outs on the SBT.
>
> When comparing to
I run the SBT through digi out into my Cyrus dacX + psxr then the dac
goes into my Glasshouse passive preamp then to my mono block amps.The
volume on the SBT is and always has been set to 100% ive never tried or
used the analogue rca outs on the SBT.
When comparing to hd direct to streaming all i
Good idea with a powered hub, the Touch may have under performed if the
HD used a lot of power from Touch's internal 5v .
I don't know the exact design here and what it can tolerate however many
external drives takes more amps than they should if they followed the
USB specs :-/
I moderate my clai
Thank you Chris !!
b2croix's Profile: http://forums.slimdevices.com/member.php?userid=57337
View this thread: http://forums.slimdevices.com/showthread.php?t=96491
___
Touch maili
Hi there.
You might get a better response in the French speaking subsection of the
forum :)
Stratmangler's Profile: http://forums.slimdevices.com/member.php?userid=20387
View this thread: http://forums.slimdevices.com/show
Bonjour,
Je suis un newbie côté serveur.
J'ai une freebox, un NAS (D-Link DNS 320), une Squeezebox Touch et
j'aimerai que SqueezeCenter soit installé sur mon NAS de telle sorte que
je puisse lire mes médias directement sur le NAS sans avoir à allumer
mon PC.
Comment dois-je faire ?
Merci pou
Thanks for the replies guys
I do run the SBT through my Cyrus dacX but the reason i asked about hd
direct is i have been using both methods but found streaming from pc via
router sounded better than hd direct but my 1 tb hd is usb powered and
yesterday i had a thought and dug out my old usb hub t
garym wrote:
> He means remove stand from the touch. But good point. One can lay it
> about however one wants
Damn, knew it was a mistake posting after a few days of business travel,
long work days and minimal sleep.
Yep, it was the Touch that I meant. I haven't got the Touch or the
Receiver to c
Hi Triode,
I just got this battery powered Legato II. The USB side is running
StreamLength USB code by Gordon Rankin.
It works great with EDO, but in order for it to go into charging mode
when not playing music, SBT must tell it that music is not streaming.
Or if USB power is cut, that would k
20 matches
Mail list logo
