Well, so much for that theory. About 7:35p it crashed again. But
unplugging the device that generates that data has allowed it to run
normally again. However, based on your response the last record in this
output would be the culprit then correct? If my count is correct, both sum
and wsum
After a little bit of battling with Python (which I'll post a description
of in a different thread once I'm all up and running) to get prereqs
installed, it appears WeeWX is speaking to my serial server connected
Vantage Pro 2 just fine.
Thanks all for the help!
Now for the fun part...
Chris
Yep, that could explain the symptoms. The accumulator for a given day and
for a given observation is at times initialised from that particular day
from that particular observation's daily summary table. If the sum field of
the day and daily summary concerned was None instead of a numeric then th
I did a little more playing with this today, and determined that the
problem is with extraTemp3, which I just started using, but is built into
the system. That being the case, I decided to drop and re-build the daily
summaries, just for fun. My theory being that was done right before the
issu
Thank you all for the suggestions! I had not noticed the IP Address option. Now
the only thing left to do is find enough time to try it out! When I do I will
report back!
Thanks again weewx community. :)
Chris
Chris Alemany
3854 6th Ave
Port Alberni, BC
V9Y4M2
h:250-723-0889
w: 250-753-3245 x2
Another alternative is with an RF link to/from your console and computer.
I use Belfryboy's XRF PCB's, but with an xbee 2.4Ghz module(s) configured
for serial data, Tx & Rx.
https://oshpark.com/profiles/belfryboy
https://learn.sparkfun.com/tutorials/exploring-xbees-and-xctu
My VP2 console is on
On Saturday, November 18, 2017 at 1:41:41 PM UTC-7, vince wrote:
>
> I'd be very interested in writeups of these kinds of setups that enable
> the VP2 console to be situated far away in the house from the actual
> computer running weewx.
>
It's not really a write up but:
My setup is very simpl
On Saturday, November 18, 2017 at 10:43:21 AM UTC-8, Thomas Carlin wrote:
>
> This should work just fine. I have my Vantage Pro2 hooked up via IP using
> a home brewed ESP8266 for a WiFi connection. Essentially, it takes the
> Serial stream, and converts it directly to IP, and the reverse for s
This should work just fine. I have my Vantage Pro2 hooked up via IP using
a home brewed ESP8266 for a WiFi connection. Essentially, it takes the
Serial stream, and converts it directly to IP, and the reverse for sent
commands. Just make sure your IP and port are correct in your
configuration