RE: Fast Switching on Cisco Routers [7:9753]

Try www.cisco.com Searched for "fast process switching" and found this in the top ten(4). http://www.cisco.com/warp/public/63/tuning.html and seems to answer most of your questions. HTH. Ken Claussen MCSE CCNA CCA "The Mind is a Terrible thing to Waste!" -Original Message- From: [EMAIL

RE: can we NAT the destination IP using IOS's NAT nature? [7:7050]

>If yes, can you show me how is the command look like? >>Hi, >>I guess you can config a static nat mapping >>and reverse the inside and outside interface. Mike, Try this instead, ip nat inside source static tcp 192.168.0.100 25 25 extendable This statement will allow mail to your rfc1918 add

RE: 2600 router - critical situation

This happened to me last week. It turned out to be a problem with the router resources. When you downloaded the IOS image it should have informed you what the minimum Hardware required to run the image is (Flash and RAM, 2600 default 8/32). After upgrading the flash, there is not an IOS image, so

NAT on 1605 with DHCP on Ethernet0

Dear Group Study, I have recently upgraded my Cisco 1605R to work on my cable connection to IOS 12.1.5T. I am finally able to negotiate an IP address via DHCP, now comes the tricky part. I wanted to implement NAT overload, "? Translating to interface's address: As a convenience for users wishing

RE: average salaries

Check out http://salary.com/home/layoutscripts/sall_home.asp It even breaks it down by Geographic location and discipline. It also gives you a high a low and a mean, which is way cool! Ken Claussen MCSE CCNA CCA [EMAIL PROTECTED] "The Mind is a Terrible thing to Waste!" -Original Message---

Re: Can't Ping Local Serial Interface of 2610

Title: Re: Can't Ping Local Serial Interface of 2610 After adding the Frame-relay Map statement, as suggested by several people, I was able to ping the local serial Interface. I then created the interface as a Sub-interface and attempted to use the Frame-relay map command and received the "You

Can't Ping Local Serial Interface of 2610

I am trying to setup a Frame Relay link in a lab situation. We have Layer 2 speaking LMI back and forth and the line Protocol is reported as Up on the serial interface. We assigned it a Private address and created a static route pointing at the serial interface of the other router. When you do a S

Can't Ping Serial Interface!

Title: COLT tests I am trying to setup a Frame Relay link in a lab situation. We have Layer 2 speaking LMI back and forth and the line Protocol is reported as Up on the serial interface. We assigned it a Private address and created a static route pointing at the serial interface of the other