Hello
can anyone help me in finding out the MIB for active users on
individual PRI (E1) on Cisco AS5300.
I already have and making an MRTG for total ppp users but i am finding MIB
for ASYNC and SYNC users individually.
Message Posted at:
Hi Navin,
Are you using VLSMed IP's on the router if so try using ip classless, it
solved my problem. if it doesn't send me your conf. b/c i faced similar
problem while connecting to ISDN from Cisco 2501.
Bye
Shakeel Shamsi
M.Sc., MCSE,CCNA,CCNP.
NKP wrote:
Hi ,
I am facing a problem on
Hello,
I have found you address while going through some archives, I was
wondering if you could personally help me with a problem, I am configuring a
router a 2600 series with IOS 12.0 for ISDN connectivity to an ISP access
server cisco AS5300, the configuration i have used has been
Hello,
I am configuring a router a 2600 series with IOS 12.0 for ISDN
connectivity to an ISP access server cisco AS5300, the configuration i have
used has been tested by me on Cisco 1603, 2501, 2503, with little changes,
the problem here is that the router connects and the after ten
Hello,
I was using a 1603 router containing the ver 12 IOS sending you the sh
ver output, as per what i have Ver 12 should work on your router.
Universal#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-NY-M), Version 12.0(14), RELEASE SOFTWARE (fc1)
Hello,
Has anyone out there ever used a PATTON 2960 Series Access server, i am
about to buy would like some market feedback about the product, refer to
www.patton.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7i=27900t=27900
I have found another configuration for configuring two serial ports for
multilink i think this configuration will work, just want an opinion from
you guys.
ip subnet-zero
multilink virtual-template 1
!
interface Virtual-Template1
ip 192.168.0.1 255.255.255.252
ppp authentication chap
ppp
Well i am using E1 for point-to-point conectivety for bandwidth transmission
(2048 kbps), the solution that you have given is load balancing where both
E1's have individual P-to-P IP's this configuration is not transparent to
the transport layer resulting in per packet load balancing. The
Hi,
I am working on combining to E1's to work as one so that the upper layers
would see the bundle as a 4Mbps link with only one point to point IP at
least that's what cisco says, i read about it on Cisco and found some sample
configurations. I would like you guys to go through this setup and
I am having an ARP trashing error on a Cisco 2501 router, read about it on
www.cisco.com. Summary is that router has a queue length of 16 to store
ARP's, a new request kicks out old ARP already in the queue thus causing
thrashing of ARP, the concerned network is crowded with HUBs, Any idea how
to
I am having problem configuring this cardinstalled this card on the 3660
with 12.1(1)T the Chassis that hold the VWic card is NM-1FE2W.
Having problem configuring both as framed for supporting Dual E1 on the
card, interface e1 2/0 is configured as framed and the other e1 2/1 is
configured as
11 matches
Mail list logo