RE: DTE interface on Frame Relay switch [7:4256]

2001-05-28 Thread suaveguru
>From what I know you could configure BACK TO BACK FRAME-RELAY WITH two routers with LMI turn off regards, Jason Yee --- Fischer Reinhold wrote: > Hi Thomas, > > i think it is not possible what you are trying to > accomplish. > You need one Router with at least two serial > interfaces dedica

Re: DTE interface on Frame Relay switch [7:4256]

2001-05-12 Thread Justin M. Clark
it can be done, i had multiple people tell me that 2 routers couldnt perform frame relay, but if you search the cisco site for back-to-back frame relay they have a configuration. i have two 2501's working fine with frame relay between s0 and s0 on both routers. the only diffence between regular

Re: DTE interface on Frame Relay switch [7:4256]

2001-05-12 Thread Shibu Pillai
Hello , It is possible . Sbp ""Thomas"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > If I am using a 2522 as a frame relay switch, can its A/S serial ports be > configured as DCE interfaces and be connected to other router DTE interfaces >

Re: DTE interface on Frame Relay switch [7:4256]

2001-05-12 Thread Thomas
If I am using a 2522 as a frame relay switch, can its A/S serial ports be configured as DCE interfaces and be connected to other router DTE interfaces using a 60pin-60pin crossover cables? I am trying to setup a fram relay switch with more than 2 routers participate (excluding the frame relay swi

RE: DTE interface on Frame Relay switch [7:4256]

2001-05-12 Thread Fischer Reinhold
Hi Thomas, i think it is not possible what you are trying to accomplish. You need one Router with at least two serial interfaces dedicated as the frame relay switch. So you need at least 3 Routers with serial interfaces to practice frame relay. Others please correct me if there is a trick to d

Re: DTE interface on Frame Relay switch [7:4256]

2001-05-12 Thread Bob Timmons
Absolutely. Go to www.groupstudy.com and search the archives. There's a lot of pertinent information there regarding back-to-back configurations. Generally, you'd connect the DCE side of the cable (it should be labeled) to the FrameSwitch and the DTEs to the 'spokes' > Hi All - I have two 2501

DTE interface on Frame Relay switch [7:4256]

2001-05-11 Thread Thomas
Hi All - I have two 2501 routers. One of them is set as a Frame Relay switch. I wonder if I can set a serial port of this router to be DTE interface and assign an IP address to it, so that I can ping this interface from the other router (using back-to-back crossover serial cable). Thanks. M