Tony
I have the same setup.
I have not tried Olivia. I have worked all other modes.
What mode is radio set too? Data mode? Is the decode button highlighted
above the waterfall in DM780?
Is band with set properly as not to cut off the signal edges both on the K3
and DM780?
Once your on the signal
Tony…
There is a SQUELCH slider near the top above the receive window (grayish
horizontal bar moving). My slider was in the middle and when I moved the slider
to the left all the way, I had solid copy. Where is yours set at?
73, Steve K6SAB
On Jun 24, 2014, at 6:47 PM, Tony Lyon
Hi Gerald,
My K3 is indeed set to Data Mode. The bandwidth is set correctly and I
also have the default settings.
I also have re-installed HRD/DM780 I also re-checked the Signalink
soundcard settings and they are OK.
Still no go... TX is fine, RX drops characters.
73,
Tony L. (KJ5XF)
Hi Steve,
I had the slider at about 25% and I moved it all the way to the left.
Still no change.
73,
Tony L. (KJ5XF)
Tony…
There is a SQUELCH slider near the top above the receive window (grayish
horizontal bar moving). My slider was in the middle and when I moved the slider
to the left
Hi Sal,
Yes, I went through the Signalink audio level config again and no change.
The Signalink pots are also set just like yours.
73,
Tony L. (KJ5XF)
Hi Tony!
Have you gone through the Signalink audio levels config procedure?
Is it possible that its just Windows audio levels that are low?
All
Tony,
First make sure that you have a good audio connection from Line Out to
the soundcard. Use good quality cables that do not pick up noise.
What happens if you eliminate the Signalink - change HRD to use the
computer default soundcard and connect from that soundcard line out to
the K3
Looking at what I sent, I got Line In and Line Out reversed.
Tony is having problems decoding, so the Soundcard Line In and the K3
Line Out are the ones that are to be moved to the computer built-in
soundcard.
73,
Don W3FPR
Tony,
First make sure
Tony
You said you used fldigi or some other software before.
Did you run Olvida? If so then hardware fine its a HRD setting.
Confirm that and I will go check mine in that mode while waiting.
Gerald
__
Elecraft mailing list
Home:
Folks,
I want to thank _/*ALL*/_ of you who sent feedback!!! I narrowed the
issue I was having with the RX
down to the the following:
a) The SQUELCH default (25%) was simply too high. I lowered it to 4%
b) For some interesting reason, I had to drop the audio input down to
about 15%. This
Folks,
I decided to try HRD/DM780 for first time after using another HF digital
software program for
probably 10 years. I am using an Elecraft K3 and a SignaLink USB
interface and both
MixW and MultiPSK fine with ZERO problems on either RX or TX. With
HRD/DM780 (version 6.2) the K3
will TX
10 matches
Mail list logo
