Thanks!
I got commuciation between linuxcnc and my development board. Now I just have
to figure out what linuxcnc send to get things done and what it expect back.
Best regards Nicklas Karlsson
On Thu, 21 Aug 2014 02:00:31 +0200
Michael Haberler wrote:
>
> Am 20.08.2014 um 19:04 schrieb Ka
On Sunday 31 August 2014 02:55:34 Gregg Eshelman did opine
And Gene did reply:
> On 8/30/2014 8:40 AM, Gene Heskett wrote:
> > I might be tempted to set it up locally just so I'd be ready if and
> > when it actually arrives at the cat5 connector on my cable modem,
> > but I've no knowledge of ipv6
On Sunday 31 August 2014 04:54:26 Andy Pugh did opine
And Gene did reply:
> > On 31 Aug 2014, at 06:19, Gene Heskett wrote:
> >
> > Bringing up the Igain
> > had the effect of slowing it quite drastically. Running at 500 revs,
> > with Igain at the default .1, raise it to 10 and it slows to abou
> On 31 Aug 2014, at 06:19, Gene Heskett wrote:
>
> Bringing up the Igain
> had the effect of slowing it quite drastically. Running at 500 revs, with
> Igain at the default .1, raise it to 10 and it slows to about 125 rpms.
If adding I gain increases the orator then something is very wrong
On 8/30/2014 8:40 AM, Gene Heskett wrote:
> I might be tempted to set it up locally just so I'd be ready if and when
> it actually arrives at the cat5 connector on my cable modem, but I've no
> knowledge of ipv6 having a private address block that will not pass thru a
> router without a NAT setup
