thanks todd
i also used the offset component
so it sounds familiar
the offset component was returned to original position simply by nudging
till offset was 0
tomp
On 02/14/2016 06:54 AM, Todd Zuercher wrote:
> I'm not quite sure I understood your reinterpretation of what I tried to
> explain.
h
From: "TJoseph Powderly"
To: "Enhanced Machine Controller (EMC)"
Sent: Saturday, February 13, 2016 10:59:27 AM
Subject: Re: [Emc-users] Rigid Tapping in U,V,W
Thanks Todd
before i dig into your code, i read the thread
and if i understand correctly, then i can rephrase what you d
Thanks Todd
before i dig into your code, i read the thread
and if i understand correctly, then i can rephrase what you did
( my standard test for whether i understand ;-)
i think you commanded W and added the delta to the W while the custom M
code was in effect.
true?
i did similar for sink edm
-questions?start=20#70064
- Original Message -
From: "robert - Innovative-RC"
To: "Enhanced Machine Controller (EMC)"
Sent: Saturday, February 13, 2016 8:54:12 AM
Subject: Re: [Emc-users] Rigid Tapping in U,V,W
yes you can tap in X Y Z no problem,
if you try it out in the 9
yes you can tap in X Y Z no problem,
if you try it out in the 9axis sim you can see U V W does not follow
spindle just goes to position in the G code, and then proceeeds to the
next line of code with no error etc
even if you switch planes or (G18 or G17.1)
my config is on a 3 axis lathe X Z top
quot;
Sent: Saturday, February 13, 2016 4:50:15 AM
Subject: [Emc-users] Rigid Tapping in U,V,W
hi
what would it take to add or finish adding U V W rigid tapping ? as i
see when you command G33.1 with a W it is accepted but goes to postion
and just does the next line of code with out doing the
hi
what would it take to add or finish adding U V W rigid tapping ? as i
see when you command G33.1 with a W it is accepted but goes to postion
and just does the next line of code with out doing the tapping move.
so it looks like someone might have started adding rigid tapping in U V W?
i use a