Re: [Emc-users] Update: Re: linuxcnc versions

Hi Phil, I changed the kernel options in the grub,  now it can find everything, debian wise. I ran the stepperconfiguration real quick,  and that one actually saves a configuration, without that python error. So I got that far/ I have both a lathe and a mill, one on one parallel port

Re: [Emc-users] Update: Re: linuxcnc versions

Hi Philip, I'll download that one and see if it is the same as what I had. did you use the GUI, txt installer or th live installer? Ron On 12/19/19 9:32 PM, Phillip Carter wrote: I just downloaded the wheezy iso from http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso

Re: [Emc-users] Update: Re: linuxcnc versions

I just downloaded the wheezy iso from http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso and installed it without any issues using the GUI install. It does give a warning about the debian-security repo but that does not cause any

Re: [Emc-users] Update: Re: linuxcnc versions

The GUI installer has problems with my wifi dongle. The dongle works fine with after install. The problem is that you can't bypass the network with the GUI installer. Dave On Thu, Dec 19, 2019, 22:41 R C wrote: > also, on that Stretch installation. if you try to install on anyting > other

Re: [Emc-users] Update: Re: linuxcnc versions

also,  on that Stretch installation.  if you try to install on anyting other then the first sata port, it names the device /dev/sde, even though it is /dev/sda I think the installer is broken, I have seen that earlier. Ron On 12/19/19 8:05 PM, Dave Matthews wrote: Odd, Stepconf ran fineon

Re: [Emc-users] Update: Re: linuxcnc versions

btw: in LinuxCNC Uspace 2.7.0Debian 9 Stretch I see linuxcnc-stretch-uspace-amd64-r12.iso

Re: [Emc-users] Update: Re: linuxcnc versions

Odd, Stepconf ran fineon the one I did. Dave On Thu, Dec 19, 2019, 21:54 R C wrote: > because a bunch of people were recommending it. > > Also, I managed to install "LinuxCNC Uspace 2.7.0 Debian 9 Stretch" > > > > BUT: there are two issues

Re: [Emc-users] Update: Re: linuxcnc versions

because a bunch of people were recommending it. Also, I managed to install "LinuxCNC Uspace 2.7.0 Debian 9 Stretch" BUT:  there are two issues with that. 1:  It does not want to install if there is more than one drive in the system,

Re: [Emc-users] Update: Re: linuxcnc versions

On Thu, Dec 19, 2019, 21:39 R C wrote: > Hello all, > > finally had some time to install the linux iso (LinuxCNC 2.7.14 Debian 7 > Wheezy ) again, > I used the link as mentioned earlier > > (http://www.linuxcnc.org/downloads/)

[Emc-users] Update: Re: linuxcnc versions

Hello all, finally had some time to install the linux iso (LinuxCNC 2.7.14 Debian 7 Wheezy ) again,  I used the link as mentioned earlier (http://www.linuxcnc.org/downloads/) I couldn't make any