have to say, the good thing about those Legacy "legs"(as Legacy called
them...the red, vertical pieces that connect the bottom rail with the top
rail) is the fact that you could adjust the front-to-back orientation of
the top rail to achieve a better parallel setup of the two top rails to
each
Better than just made in the USA, it’s made in Oregon! Home sweet home!
Tim,
Very nice work. The BIG Deal on your tape - in addition to the
"OrnamentalMills.com" of course - was the "USA"!
I trust that that means "they" (assuming you had several made) were "Made in
the USA" (Like we always
---
From: 'Curt George' via Legacy Ornamental Mills
Sent: Jan 26, 2020 10:59 PM
To: legacy-ornamental-mills@googlegroups.com
Subject: Re: Thank you Tim & today's project.
Hello Mac.I can take some more pictures if you like.(but I don't have any more
pictures of this set up at this min.)
th
PM
To: legacy-ornamental-mills@googlegroups.com
Subject: Re: Thank you Tim & today's project.
Hello Mac.I can take some more pictures if you like.(but I don't have any more pictures of this set up at this min.)the idea was to mount onto the Legacy's extruded alum, rail. in this case
m which lead me to The Group's site.Thanks again for all you do.Mac-Original Message-
From: artmarb...@comcast.net
Sent: Jan 26, 2020 10:10 PM
To: legacy-ornamental-mills@googlegroups.com
Subject: RE: Thank you Tim & today's project.
Great Curt, you’re welcome. I had these made up for a
Nice Work Curtis,
Looking forward to your testing time.
Kind Regards,
Timothy J. Ziegler
Ziegler WoodWork & Specialty
14171 160th Ave.
Foreston MN 56330
320-294-5798 shop
320-630-2243 cell
On Sun, Jan 26, 2020 at 12:58 PM 'Curt George' via Legacy Ornamental Mills <
' via Legacy Ornamental Mills
Sent: Jan 26, 2020 8:14 PM
To: 'Curt George' via Legacy Ornamental Mills
Subject: Re: Thank you Tim & today's project.
Hello again everyone.On the nut inserts that I used for my support bracket cost $11.00 for 50 on Amazon. I made my own tool for flaring
Great Curt, you’re welcome. I had these made up for a project idea that did
not pan out. Notice how fine the increment markings are? The tapes are custom
of my own design so of course I had to have our name put on them.
--
You received this message because you are subscribed to the
Original Message-
From: 'Curt George' via Legacy Ornamental Mills
Sent: Jan 26, 2020 6:25 PM
To: legacy-ornamental-mills@googlegroups.com
Subject: Re: Thank you Tim & today's project.
Thanks Mac.But honestly? Joe jealous of anything I have...? I just don't see it happening. ;-) T
26, 2020 1:57 PM
To: Legacy ornamental mills
Subject: Thank you Tim & today's project.
Hello Everyone.First off I would like to Thank Tim Krause for the new center
rule tape that he sent me.
Today's project is are 4 support brackets for my Legacy. I am not sure if this
was needed,(or
Thank you Tim & today's project.
Hello Everyone.First off I would like to Thank Tim Krause for the new center rule tape that he sent me.Today's project is are 4 support brackets for my Legacy. I am not sure if this was needed,(or if anyone else will need anything like this but Its my atte
11 matches
Mail list logo