groups.com
Sent: Sunday, November 8, 2015 4:36:40 PM
Subject: RE: new member with Legacy 1200
Thanks mac that’s what I was trying to say, I assembled one of my mills once
with one one-way and one the other and it was very stiff
And when I made them both the same way it was nice and smooth
-ornamental-mills@googlegroups.com
[mailto:legacy-ornamental-mills@googlegroups.com] On Behalf Of MWF
Sent: Monday, 9 November 2015 3:31 AM
To: legacy-ornamental-mills@googlegroups.com
Subject: RE: new member with Legacy 1200
Don, You brought up a good item of discussion here. Thank you for
x27;s military.Mac-Original Message-
From: Bill Bulkeley
Sent: Nov 8, 2015 2:43 AM
To: legacy-ornamental-mills@googlegroups.com
Subject: RE: new member with legacy 1200
Not sure if its worth mentioning but check
and make sure the rails are all the correct way
t: Saturday, November 7, 2015 10:40:42 PM
Subject: Re: new member with legacy 1200
Thanks Curtis,
I saw the dynaglide lubricant on the Legacy website but didn't buy any yet.
I'll get some dynaglide and try it. It's the X axis is giving me a little too
much restriction. The Y axis
-ornamental-mills@googlegroups.com]
Sent: Sunday, 8 November 2015 2:41 PM
To: Legacy Ornamental Mills
Subject: Re: new member with legacy 1200
Thanks Curtis,
I saw the dynaglide lubricant on the Legacy website but didn't buy any yet.
I'll get some dynaglide and try it. It'
Thanks Curtis,
I saw the dynaglide lubricant on the Legacy website but didn't buy any
yet. I'll get some dynaglide and try it. It's the X axis is giving me a
little too much restriction. The Y axis (carrier tray) isn't too bad.
When I got the machine, I cleaned out the saw dust from all the
http://www.thewoodworkingshows.com/featured_products/dynaglide-plus-lube-spray
C.A.G.
- Original Message -
From: "CURTIS GEORGE"
To: legacy-ornamental-mills@googlegroups.com
Sent: Saturday, November 7, 2015 8:45:50 PM
Subject: Re: new member with legacy 1200
Hello Do
d, is
nothing more then a refinement of the basics.)
Have a good night.
And Good luck On you slide movement.
C.A.G.
- Original Message -
From: "wilknd via Legacy Ornamental Mills"
To: "Legacy Ornamental Mills"
Sent: Friday, November 6, 2015 7:34:01 PM
Subject: ne
Hi. Glad to have found this group. Recently purchased a 1200 with
motorized lead screw and motorized turn table. I am disappointed in the
difficulty with moving the carriage by hand. I would like to use this with
templates to use as an overarm router but believe this will be very
difficult.