I just ordered a pair of the RH thread ends, about $7/each. Rather than pop
$40+ for the whole rod, I’ll find some threaded rod at my local Ace Hardware
and make one up to measure.
Fortunately, the EPC does designate whether they’re RH or LH thread.
Thanks again for the suggestion!
-D
> O
On my spare the adjustment range is a minimum
of 3" to a max of 4" with about 5mm in the
bore. I don't see any numbers on the parts
themselves but there is a small stamp in each
R or L respectively. The one you want with
the right hand thread is 123 328 00 63. The
threads are the size that us
Check to see if just the ball/stud part is sold. Last time I replaced a
similar link on the SLS control valve, the two ends were about $8 each, but the
whole assembly was $75 or so.
--
Max Dillon
Charleston SC
On May 22, 2019 11:11:37 AM EDT, Dan--- via Mercedes
wrote:
>This car has xenon he
Great idea, Mannfred! The only concern would be if it’s at or near the correct
length. The part on this car is a fixed length, there’s no adjustment. I
realize the W123 part would be adjustable, but if it’s too long or short it
wouldn’t of much use.
If I knew which one was right hand thread I w
OK found the pack sooner then I thought.
there are two ends one aright hand thread and
one a left. you will need one of each for
each of the connector bars.
the numbers are 123 328 00 63 and 123 328
01 63 my cost $7.24 each. From those numbers
the parts guy should be able to get the
number
That sounds like the same piece that is used
on the w123 TD for the rear leveling of the
suspension. The ends are available for like
around $5-$8 if I remember the last ones I
bought. Or you can get the complete piece
with the thread part for around $40 or so.
I'll try to find the number.
M
This car has xenon headlights. A part of this system is two level sensors, one
at the front and one at the rear. The sensor is bolted to the vehicle frame and
a lever on the sensor, using much like a sway bar link, is connected to the
lower control arm at that location.
I found the rear sensor
