Phoebus Dokos writes:
<>
>... The systems starts fine
>but once you spend 3 to 4 minutes it hopelessly crashes...
>Something heats up and that something I haven't found yet...
>My next move will be to get zero temp. spray to start
>spraying one by one the chips to see if the system will last
>lo
At 03:40 ìì 11/9/2002, you wrote:
>Phoebus, my Minis-QL Aurora system sometimes fails to start. The cure
>is to remove or clean contacts on the EPROM cartridge which contains
>the SuperHErmes code. As it's a RomDisq in your case, I doubt it's
>this but this does seem to be the one thing not trie
mine would completely fail to start, the SGC gave a 'contact
Miracle Systems' message and stripes ont he screen.
Dilwyn Jones
- Original Message -
From: "Phoebus Dokos" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: 10 September 2002 00:08
Subject: Re: [ql-user
At 06:58 ìì 9/9/2002, you wrote:
>On 09/09/02 at 18:19 Phoebus Dokos wrote:
>
> >>Does the problem happen without Qubide?
>
> >Yep it does...
>
>Well, then the next step is, do you have a regular QL?
>
>Nasta
Yes I do... (btw: I unplugged the memory chips from the SGC and same thing
happened)
On 09/09/02 at 18:19 Phoebus Dokos wrote:
>>Does the problem happen without Qubide?
>Yep it does...
Well, then the next step is, do you have a regular QL?
Nasta
At 05:42 ìì 9/9/2002, you wrote:
>Hello Phoebus,
>
>This is just an idea... try checking the ram chips on the SGC board. I
>once had similar problems and the solution was to deinstalled and install
>again the ram chips. Or maybe a failed chip?
I was trying to avoid getting there ;-) My lac
Hello Phoebus,
This is just an idea... try checking the ram chips on the SGC board. I once had
similar problems and the solution was to deinstalled and install again the ram chips.
Or maybe a failed chip?
Does the problem happen without Qubide?
regards
Davide
> starting yesterda
On Mon, 09 Sep 2002 13:49:00 -0400 Phoebus Dokos <[EMAIL PROTECTED]>
writes:
>
> At 01:00 ìì 9/9/2002, you wrote:
> Okay cleaned both the Aurora Scan and 8302 chips after putting
> them
> back fabulus green screen. jiggle stuff around a bit boots up
> normally,
> starts SMSQ/E... 2 m
At 01:00 ìì 9/9/2002, you wrote:
Okay cleaned both the Aurora Scan and 8302 chips after putting them
back fabulus green screen. jiggle stuff around a bit boots up normally,
starts SMSQ/E... 2 minutes into it... CRASH
Any other ideas?
Phoebus
At 01:00 ìì 9/9/2002, you wrote:
Okay cleaned both the Aurora Scan and 8302 chips after putting them
back fabulus green screen. jiggle stuff around a bit boots up normally,
starts SMSQ/E... 2 minutes into it... CRASH
Any other ideas?
Phoebus
At 01:24 ìì 9/9/2002, you wrote:
>On Mon, 9 Sep 2002, ZN wrote:
>
> > Never the less, if you hvae anything to do it with, check the power supply
> > voltages, it may point to another problem.
>
>"The Dokos Effect"? ;)
I (h)rea(r)d that :-)
Phoebus
>Dave
On Mon, 9 Sep 2002, ZN wrote:
> Never the less, if you hvae anything to do it with, check the power supply
> voltages, it may point to another problem.
"The Dokos Effect"? ;)
Dave
At 01:00 ìì 9/9/2002, you wrote:
>On 09/09/02 at 12:17 Phoebus Dokos wrote:
>
> >>> Hi all,
> >>> starting yesterday, my Aurora setup began experiencing weird lock-ups,
> >>> either during startup, or after it runs for 3 or four minutes.
>
> > Thanks Nasta, I had a hard drive on it as well (WDC6
On 09/09/02 at 12:17 Phoebus Dokos wrote:
>>> Hi all,
>>> starting yesterday, my Aurora setup began experiencing weird lock-ups,
>>> either during startup, or after it runs for 3 or four minutes.
> Thanks Nasta, I had a hard drive on it as well (WDC6100AL) so the load (I
> would imagine) is ade
At 11:48 ðì 9/9/2002, you wrote:
>On 09/09/02 at 11:07 Phoebus Dokos wrote:
>
> >Hi all,
> >starting yesterday, my Aurora setup began experiencing weird lock-ups,
> >either during startup, or after it runs for 3 or four minutes.
> >
> >My complete Aurora setup:
> >
> >Q-Plane/QubIDE w/ QubIDE 2.
On 09/09/02 at 11:07 Phoebus Dokos wrote:
>Hi all,
>starting yesterday, my Aurora setup began experiencing weird lock-ups,
>either during startup, or after it runs for 3 or four minutes.
>
>My complete Aurora setup:
>
>Q-Plane/QubIDE w/ QubIDE 2.01 /SGC/SuperHermes/2 Mb RomDisQ -on its
>origin
Hi all,
starting yesterday, my Aurora setup began experiencing weird lock-ups,
either during startup, or after it runs for 3 or four minutes. It appears
that the lock-ups do not affect the superHermes (and/or the superHermes
Lite) as when I type anything, the keyclick continues. The lock-ups
17 matches
Mail list logo