Re: [RCSE] cutting accurate templates for foam cutting

2001-08-02 Thread John Gossett
--- Cesar Managad [EMAIL PROTECTED] wrote: Then, I'll lay them down on my uncut template material, .02 thick phenolic material. What is phenolic material and where does one purchase it? I used thin aircraft ply to make my terminator templates following essentially the same procedure as you

RE: [RCSE] cutting accurate templates for foam cutting

2001-07-31 Thread Joel A. Foner
The two ways I have thought of are; cutting out the paper template and trying to retrace the image onto the template and pushing pin holes through the paper onto the template material creating a connect the dots outline. But neither sounds very professional. How about gluing the printed

RE: [RCSE] cutting accurate templates for foam cutting

2001-07-31 Thread Tripp Meister
Follow up question, what do you use as template material? -Original Message- From: Joel A. Foner [mailto:[EMAIL PROTECTED]] Sent: Tuesday, July 31, 2001 8:46 PM To: [EMAIL PROTECTED]; [EMAIL PROTECTED] Subject: RE: [RCSE] cutting accurate templates for foam cutting The two ways I

Re: [RCSE] cutting accurate templates for foam cutting

2001-07-31 Thread Cesar Managad
built one too), you'll need six templates. It takes about an hour total with this method. Cesar - Original Message - From: [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Monday, July 30, 2001 1:26 PM Subject: [RCSE] cutting accurate templates for foam cutting Hi, I'm trying to setup foam