Hi Corey How bad are the new Chinese Apollo's steel iron shafts? I had a lot of trouble trying to use this shaft ... confusing. I'm going back to using TT. A lot of Tier I automotive parts are being sourced to China. Thanks Harry S www.Golf54.com
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Corey Bailey Sent: October 16, 2003 12:26 AM To: [EMAIL PROTECTED] Subject: RE: ShopTalk: Residual Bend N plane - Steel Shafts Gee, I have to wonder about TT's QC process. Until the recent reintroduction of the Chinese Apollo's, they were consistently the worst shaft I measured for residual bend. Some worse than 40 thousandths of run-out. CB At 02:06 PM 10/15/2003 -0400, you wrote: >FWIW, they also check each shaft for straightness and have an elaborate >bending machine that takes out any irregularities. > >Al
