David did you use a split grip in both cases or did you use the split grip before you butt cut the shaft and the full grip after assembly?
llhack
----- Original Message -----Sent: 3/18/04 6:36:48 AMSubject: ShopTalk: swingweight questionHi Jent's,
I came across something I don't understand.
When mocking up a set of irons and determining how much weight I was going to need to add to get my desired swing weight I would get one # say d-1 before butt cutting, this would leave a few inches of butt protruding past the seat or stop which should if anything give me a SW # that is slightly less than the # I would get after the final butt trim due to several inches of shaft hanging past the edge at the butt end or so you would think.
Low and behold after butt trimming and rechecking I found that the SW actually went down a couple of points.
How could this be?
David
