I mentioned this about 2 years ago. After years
of screwing around with old golf tubes, hoses, towels, and whatever else I could
think of to keep a grip from exploding, I made a "wrap" that works.
I acquired of a piece of upholstery leather
(Naugahyde works also) roughly 12" x 12". I sewed a length of 2" wide
velcro along one edge of the leather. I sewed the "loop" piece of velcro on the
opposite side of the leather, about 3 1/2" from the edge that the first piece of
velcro was sewn to. To use the "tool" I start by wrapping the non-velcro
edge around the grip until the two velcros meet. Then I blow the grip off.
I've yet to have a grip explode. However, not all grips will pop off. Thin
walled grips, like some of early Callaways and most all the big butt grips
simply don't want to come off with compressed air alone. Squirting a little
solvent usually helps but again, not always.
In the same post, I mentioned that air from a
compressor causes more problems than it solves. I have a 120 V. Sears tire
inflator that works better than a shop compressor simply because the air is
"pulsed" rather than a steady stream.
However, I also said that generally
speaking, blowing a grip off is pretty much a waste of time. Unless the grip is
an OEM or a relatively new one, I just cut them off. But if I absolutely have to
save a grip, I've found the easiest method is to slip a thin, flat,
narrow metal strip, lubricated with a little solvent, under the grip.
GS and GW sell ready made tools. Mine is home-made. I have never failed to
remove a grip, including Winn's, using this method.
TFlan
BTW: Believe it or don't, but a towel wrapped
around the grip works as well as most other compressed air methods.
|
- Re: ShopTalk: Grips and compressed air DADUGALLY
- Re: ShopTalk: Grips and compressed air Arniesclubs
- Re: ShopTalk: Grips and compressed air tflan
- Re: ShopTalk: Grips and compressed air Ed Reeder
- Re: ShopTalk: Grips and compressed air tflan
- Re: ShopTalk: Grips and compresse... comgolf
- Re: ShopTalk: Grips and compr... tflan
- Re: ShopTalk: Grips and c... Jeremy Ingle
- Re: ShopTalk: Grips and c... tflan
- Re: ShopTalk: Grips and c... Corey Bailey
- Re: ShopTalk: Grips and c... Ron Kellison
- ShopTalk: 1 X 42" Be... Harry F. Schiestel
- Re: ShopTalk: 1 X 42"... Lilyan Silver