Gathering knowledge. Your input is always appreciated and very informative. I already have a flat line set and in all honesty I have not felt or seen any difference in scoring and in feel. For me to feel the difference I would have to hit a flat line 7 iron and a sloped 7 iron on the range and so on. I also assume that the human body does adjust to a different feel after a while. My wedges do not go any higher than before. If anything my clubs do not feel boardy except in November when the cold temperature sets in. André.
----- Original Message ----- From: "Dave Tutelman" <[EMAIL PROTECTED]> To: <ShopTalk@mail.msen.com> Sent: Friday, August 25, 2006 5:17 PM Subject: Re: ShopTalk: Flatline vs frequency chart > At 03:20 PM 8/25/2006, André Cantin wrote: > >If you were to install a flat line set in the NF4 at a constant distance > >from let's say the butt end of the club would the Nf4 record the same load > >or a different load for each club? > > My analysis (see > http://www.tutelman.com/golfclubs/frequency.php ) > suggests that, to accomplish a constant > frequency, you would need to provide a slight > reverse trim to the raw shafts. (That is, the raw > shaft for the longer iron should have a higher > load than the shorter iron.) You don't want to do > this as much as the usual trim you apply for a "normal" slope. > > But a lot of clubmakers have tried constant trim > (which, in NF4 terms, really equates to constant > load), and found that to be plenty close enough to constant frequency. > > Have you made up your mind to try a > constant-frequency set? Or do you have a customer > insisting on one? Or are you just gathering knowledge? > > Good luck! > DaveT > > > -- > No virus found in this outgoing message. > Checked by AVG Free Edition. > Version: 7.0.405 / Virus Database: 268.11.5/426 - Release Date: 8/23/2006 > > > > > -- > Internal Virus Database is out-of-date. > Checked by AVG Free Edition. > Version: 7.1.394 / Virus Database: 268.10.9/417 - Release Date: 11/08/06 > >