You can just leave it going and go to work , bed ..vacation even, or
whatever.
But before you do, feel the transformers for excessive heat. They
shouldn't get more than barely warm.
If anything is hot, there's some sort of incompatibility with the local
power grid.
It takes as long as it does.
Since water varies so widely, time cannot work.
The Pup monitors conductivity like a PPM meter.
The spinner thing doesn't ever stop until you stop it BTW.
Ode
At 08:30 AM 6/6/2008 +0100, you wrote:
Hi Kathryn, yes we were all running in and out every while, looking to see
if the little light was on and the little spinning thingy was still going
(sad lot we are!) but as might have been guessed, I already have a
problem. It is a Silver Puppy and I put it in SWAP/auto mode and although
it said it could take significantly longer than four hours, it still
wasn't done in seven hours. Light is dimmer but still on. So, being that
I had to go to bed then, I turned it off. Question is, should I just put
it all back on this morning, or start again? And does anyone think it
would have been better in DC mode? I did it this way as I thought there
would be less build up. Over to you gurus out there! Dee
-------Original Message-------
From: <mailto:clay...@skypoint.com>Clayton Family
Date: 06/06/2008 04:20:25
To: <mailto:silver-list@eskimo.com>silver-list@eskimo.com
Subject: Re: CS>First batch
Good for you! It is fun to use right away, it has more zing to it.
What kind of machine did you get?
kathryn
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 270.0.0/1486 - Release Date: 6/5/2008
6:29 PM
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: silver-list@eskimo.com
Address Off-Topic messages to: silver-off-topic-l...@eskimo.com
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <mdev...@eskimo.com>
