Found it ... see below.  Question - if using RO water to start would you
still need to "double distill"?  I haven't bought my distiller yet but it
begins to seem like a hell of a lot more work to make the distilled water
than it is to make the EIS.

Jaxi
**
*How to use a tabletop water distiller to produce very low conductivity,
high quality distilled water used to make ionic/colloidal silver water.*

1.    Remove the carbon discharge filter.  It makes the water conductive.

2.    Fill the boiling chamber no more than 3/4 full.

3.    Distill only 1/2 gallon into the receiver.

4.    Discard the remainder in the boiling chamber.

5.    Repeat steps 2,3 and 4.  You now have one gallon in the receiver.

6.    Put 3/4 gallon of this water in the boiling chamber.

7.    Distill only 1/2 gallon into the receiver.

You now have what is called double distilled water.

Allow to cool and try to use it.  It should measure less than 1 microsiemen
using a PWT meter..

On Mon, Aug 16, 2010 at 9:53 AM, Trem <[email protected]> wrote:

> Try using the method shown just above the links at the bottom of this page.
> http://www.silvergen.com/links_resources.htm
>
> "How to use a tabletop water distiller to produce very low conductivity,
> high quality distilled water used to make ionic/colloidal silver water."
>
> Trem
>
>
>