Yes sir I did thank-you much, does yours look like it?
Debbie



________________________________
From: paul catania <[email protected]>
To: [email protected]
Sent: Sun, September 19, 2010 10:34:19 PM
Subject: Re: CS>Re:STRUCTURED VORTEX WATER DEVICES


Debbie, did you get the message with the attached photos?
Paul
----- Original Message ----- 
>From: Deborah Gerard 
>To: [email protected] 
>Sent: Sunday, September 19, 2010 5:17 PM
>Subject: Re: CS>Re:STRUCTURED VORTEX WATER DEVICES
>
>
>Paul,
>Any chance you could post a picture?
>Debbie
>
>
>
>
________________________________
From: paul catania <[email protected]>
>To: [email protected]; [email protected]; 
>[email protected]; [email protected]; 
>[email protected]
>Sent: Sun, September 19, 2010 7:49:28 PM
>Subject: CS>Re:STRUCTURED VORTEX WATER DEVICES
>
>Dear Brooks and group,
>
>
>
>I don't know what the inside of a "vitalizer plus" looks like, but after 
>reading 
>your suggestions, I started to play around with an old blender of mine. I took 
>out the bottom criss-crossed blade assembly, and with a pair of pliers, made 
>the 
>cross shaped blades parallel so that both blades were one on top of another, 
>facing in the same direction. I then tried to bend the ends of each up as far 
>as 
>I could, so as to end up with two U shaped blades, one slightly bigger than 
>the 
>other, on top of each other, facing in the same direction.
>
>Filling the container up with water, placing the blender on the low setting, 
>and 
>pulsing the lowest speed hanks, Paul
>
>>