Hi Debbie,
                 That IS mine. That's the one I made, but I'm not so sure if it 
works. That's why I asked Brooks for his opinion.
Paul


  ----- Original Message ----- 
  From: Deborah Gerard 
  To: [email protected] 
  Sent: Monday, September 20, 2010 4:00 PM
  Subject: Re: CS>Re:STRUCTURED VORTEX WATER DEVICES


  Yes sir I did thank-you much, does yours look like it?
  Debbie




------------------------------------------------------------------------------
  From: paul catania <[email protected]>
  To: [email protected]
  Sent: Sun, September 19, 2010 10:34:19 PM
  Subject: Re: CS>Re:STRUCTURED VORTEX WATER DEVICES


  Debbie, did you get the message with the attached photos?
  Paul
    ----- Original Message ----- 
    From: Deborah Gerard 
    To: [email protected] 
    Sent: Sunday, September 19, 2010 5:17 PM
    Subject: Re: CS>Re:STRUCTURED VORTEX WATER DEVICES


    Paul,
    Any chance you could post a picture?
    Debbie




----------------------------------------------------------------------------
    From: paul catania <[email protected]>
    To: [email protected]; [email protected]; 
[email protected]; [email protected]; 
[email protected]
    Sent: Sun, September 19, 2010 7:49:28 PM
    Subject: CS>Re:STRUCTURED VORTEX WATER DEVICES

    Dear Brooks and group,



    I don't know what the inside of a "vitalizer plus" looks like, but after 
reading your suggestions, I started to play around with an old blender of mine. 
I took out the bottom criss-crossed blade assembly, and with a pair of pliers, 
made the cross shaped blades parallel so that both blades were one on top of 
another, facing in the same direction. I then tried to bend the ends of each up 
as far as I could, so as to end up with two U shaped blades, one slightly 
bigger than the other, on top of each other, facing in the same direction.

    Filling the container up with water, placing the blender on the low 
setting, and pulsing the lowest speed hanks, Paul

    >