As EIS. Marshall
needling around wrote:
Did you run it through the vortex as CS or as distilled water and then make CS out of it?I'm thinking of trying this as I have lots of hi gauss magnets around. Thanks. PT----- Original Message ----- From: "Marshall Dudley" <[email protected]>To: <[email protected]> Sent: Tuesday, September 21, 2010 4:02 PM Subject: Re: CS>Re:STRUCTURED VORTEX WATER DEVICESActually when I was making and selling the Silver Lightning 5 ppm CS I ranit through such a vortex structuring device. I had many very good reportson the effectiveness of the product, but never ran any tests to see if thehttp://www.futuretechtoday.com/health/Products/Water-Products/structured-water-unit.htmlstructuring made any difference or not. Marshall Dick Rochon wrote:What effects have been noticed by magnetizing colloidal silver in a structured vortex device? Adding hydrogen peroxide to CS is suppose to increase the effectiveness of CS up to 300% by reducing the particle size. How would you know that magnetizing or structuring it made it more effective?Dick----- Original Message ----- From: "Brooks Bradley" <[email protected]>To: <[email protected]> Sent: Monday, September 20, 2010 8:02 PM Subject: Re: CS>Re:STRUCTURED VORTEX WATER DEVICES Dear Paul, It is encouraging to observe list researchers...such as yourself.....experimenting with existing devices in an effort to obtain devices superior to what the market customarily offers. Since we have not attempted to use materials generated from "circulating" water structuring material in a confined container---I cannot offer useful comment on the efficacy of such an approach. All of our material has been produced via a "one-pass" arrangement wherein the subject material is exposed to both a magnetic field and vortex formation.....simultaneously.....one-time only. My principal concern for using any form of " standing-wave" vortex would be possible destabilizing effects occurring because of possible non-laminar flow manifesting as a result of chaotic mixing at the bottom of the vortex. The question becomes, What is the actual effect of continuous re-introduction....from the centrifugal discharge at the bottom vortex section........ of the liquid components? I have no real idea. It would, indeed, be interesting to determine if one could be "reinforcing" the structuring phenomenon, or "continually disrupting" the structuring process----through the use of such a device as your modified blender? My apologies for being unable to assist you further in this, particular, matter. Sincerely, Brooks Bradley.On Sun, Sep 19, 2010 at 6:49 PM, paul catania <[email protected]> wrote:Dear Brooks and group,I don't know what the inside of a "vitalizer plus" looks like, but after reading your suggestions, I started to play around with an old blender of mine. I took out the bottom criss-crossed blade assembly, and with a pair of pliers, made the cross shaped blades parallel so that both blades were one on top of another, facing in the same direction. I then tried to bend the ends of each up as far as I could, so as to end up with two U shaped blades, one slightly bigger than the other, on top of each other, facing in the samedirection.Filling the container up with water, placing the blender on the low setting, and pulsing the lowest speed button, produces a nice little vortex. I also placed a heavy rubber band on the outside of the receptacle to hold two ofPeter Kulish's magnets, 180 degrees apart from each other.According to your research, Brooks, can this be a valid method of producingstructured water? Can I use plain tap water with a pinch of Himalayan sea salt? How can I measure the quality, or lack thereof, of the water produced? Thanks, Paul----- Original Message ----- From: "Brooks Bradley" <[email protected]>To: <[email protected]> Sent: Thursday, September 16, 2010 2:11 PM Subject: Re: SO>STRUCTURED VORTEX WATER DEVICESDear Paul, About 15 years ago, inspired by the works of Walter Schauberger....we investigated (extensively) a number of various means for "structuring" ordinary tap-water. By structuring, I mean modifying the micro-particle spectrum of what is, sometimes, referred to as the crystal-structure of water. Briefly, the theory is to modify the alignment of the atomic/sub-atomic particle structure of water....from a random/chaotic...to an arranged linear relationship. We employed a number of different approaches, including charged electrical fields; chemically-seeded catalyst solutions and various vortex-based approaches. Some success was achieved from most of the approaches. However, the most cost-effective...by far.....proved to be a simple permanent-magnet X physical vortex generation system----available to the DIY person-----for several dollars. The theory-of-operation is simply to expose a liquid experiencing a vortex geometry.......to a relatively-high, fixed magnetic field. The most operationally acceptable, cost-limiting system we were able to facilitate consisted of two 2 liter soft-drink bottles (connected to-to-top), with the top bottle having two "strong" rare-earth or neodymium magnets taped in a 180 degree relation, as close to the bottle mouth as physically acceptable. One physical modification was employed on the "top"bottle. The modification was to cut the bottom (which becomes the top)of the upper bottom----off, to form a funnel of desired size. It makes no difference which magnet has its N or S pole facing in....so long as the OTHER magnet has the opposite pole facing the first magnet. In our initial experiments, we,simply, placed the TOP section facing down (neck with magnets attached)against the bottom (with its opening facing UP) and taped the assemblytogether ---at the joint---with electrical tape. The candidate water sample was just poured into the top of the funnel section at a "slight" angle (clockwise rotation proved best) to establish the initial vortex generation---and emptied the liquid sample. Later, we obtained commercial connectors (with two female ends fused together) for a very nominal cost.......to replace our home-made connection assembly. There were multiple modifications evident in the "structured" water from the bottom container. Most notable was a decrease in surface tension, withits corresponding increase in "solubility" characteristics of the waterproper. This protocol DID NOT, of itself, modify the existing ph ofthe water sample candidates, however, the improved "solvent effect" ofthe water proved to be of large benefit (sometimes 200 percent). The mineral content of the candidate water samples DID make a difference in the actual degree of improved solvency.......but improvement presented in EVERY case exposed to this methodology. We were, through the implementation of electrical stimulation procedures....to make very acceptable alkaline water. However, my present comments are restricted to structural modifications only. I hope these comments have been of use to some of the membership. Sincerely, Brooks Bradley. p.s. I believe it to be of some moment to mention that we have evaluated a number of the commercial units (both structured water types Only, and Combination Units claimed to address both ph and physical structuring),,,,,all with varying degrees of success. Our greatest criticism being that they were ALL, horrendously OVERPRICED for the levels of performance obtained. At least that was our conclusion. I would add that we have...for years now. utilized the above-mentioned Magnet X Funnel system for treating our CS......as we pour it up after initial generation.On Wed, Sep 15, 2010 at 3:16 PM, paul catania <[email protected]>wrote:Is anyone familiar with vortex structured water devices? I am reallyconfused by how many there are, how similar they look and by how much variation there is in price. I'm including links to some of the ones Ilooked at. I would appreciate comments on any of the devices individually, and/or the technology as a whole.http://www.structuredwaterunit.com/ http://ultimatestructuredwater.com/home_unit.htm http://photonicwater.com/ Paul--The silver-off-topic-list is a moderated forum for silver-list membersto discuss topics not appropriate on the main list. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe> To post: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]>-- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe>Archives: http://www.mail-archive.com/[email protected]/maillist.htmlOff-Topic discussions: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]>..

