Dear Beth:

                To make it as simple as possible .Set your tester on DCvolts
50V for the three battery unit . If it reads 27 Volts it is fine . The single
bat. unit on a lower setting  10 V DC it will read the battery voltage . If not
follow back up the line until you get the correct reading that is at the new
batteries. If you don't have a plug such as an RCA plug be sure the alligator
clips don't touch each other . Usually you will find a bad solder joint.
        You will probably get a snow job from some of the experts on
complicating things.

                Have fun .
                Bob


G&B Rogers wrote:

> Hi,
> I was hoping that someone could help a person with minimum tech
> understanding (me<G>).  I have two CS generators, one that I purchased made
> with 1 nine volt battery where the silver electrodes are soldered directly
> to the battery cap connector ends, and the second one I made that uses the
> three 9v batteries where the connectors are soldered in series to two
> alligator clips.  I want to check the connections, since both seem to be
> working not quite as effectively as in the past, and the batteries are new.
> I bought a simple multitester multimeter device from Radio Shack (with which
> I checked the batteries).  I believe that to test the resistance of both
> generators (Rx1K Ohms is the function  per the manual) will verify that the
> connections are good.  However, I'm not sure, and was wondering what the
> proper way to do the test is and which part of the generator I should
> connect the tester leads to  - the battery cap connector nodes or the
> electrodes (on the direct solder generator)/ alligator clips.  Also, what
> should I be looking for? (When you set the Rx1k Ohms function, you touch the
> positive and negative leads together, the meter goes to zero.  If it is
> working, will the generators also cause the meter to go to zero?)  The
> multitester measures AC, DC voltages, DC current and resistance.  I hope
> that one of these functions will be useful for testing the connections of
> the generators before I take them apart and resolder (which I don't want to
> do if I don't have to).
> Thank you in advance for help!
> Beth
> --
> Commit Random Acts of Kindness
>
> ----------
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> To join or quit silver-list or silver-digest send an e-mail message to:
> [email protected]  -or-  [email protected]
> with the word subscribe or unsubscribe in the SUBJECT line.
>
> To post, address your message to: [email protected]
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
> List maintainer: Mike Devour <[email protected]>