Jay:

This is not really true.  Tests comparing efficacy based on PPM never
disclose the quality of the silver products used.  It is more likely in
these test cases, that the quality of the higher PPM products were not to
standards compared with the less concentrated versions.

Reference the University of North Texas studies.  This is not the only study
comparing efficacy by concentration, just one of the only publically
available ones.  I haven't seen a lower PPM isolated silver product
outperform a higher PPM one, provided those making the silver knew what they
were doing ( and the same quality method was used to make all products
compared without sacrificing quality ).

Also, reference the works of Dr. Ronald Gibbs who wrote a fantastic book
which, among other things, explains the dilution factor of colloidal silver
when used in the body.  Concentration becomes an issue when we consider the
dilution factor.  Remember, most of those low PPM ( below 3 PPM  - 3 PPB )
studies were done by companies studying silver as used in water systems.  In
a drinking water system, you're not starting with a heavy bacterial load.
You only have to control growth.  The water to be treated is drinking
quality to start with.

I would say:  Quality before concentration is definately a good rule of the
thumb, but there are those that can produce a very high quality 10-15 PPM
product, and a few that I'm aware of that can push that envelop a bit higher
( isolated silver products ).

Best Regards,

Jason

----- Original Message -----
From: "Jay Ice" <[email protected]>
To: <[email protected]>
Sent: Friday, May 30, 2003 10:41 AM
Subject: Re: CS>New to CS - Need Opinions/Advice


> Hi,
> This has been brought up many times. In all the testing they've done 3ppm
> has been better than 5ppm and 5 better than 10 and 10 better than 20. When
> it comes to CS more isn't better. Hope this helps.
> Ice
>
>
>
>
> From: "Ruth Bertella" <[email protected]>
>
>
>
> > I am relatively new to the list and totally new to CS (just received my
> > generator this past Tuesday - thanks Ken!!).  The generator makes 24 ppm
> CS.
> > I've been reading that lower ppm's are possibly better?  If I have 1/2
> > gallon 24 ppm CS and dilute it with 1/2 gallon distilled water, would
that
> > give me 12 ppm CS?  And is that really better?
> >
>
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> Instructions for unsubscribing may be found at: http://silverlist.org
>
> To post, address your message to: [email protected]
>
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
>
> List maintainer: Mike Devour <[email protected]>
>