Reid Harvey wrote:

> Marshall,
> I've gotten to thinking:  if silver chloride disolves little by little,
> tiny amounts getting into the filtrate, isn't it likely that the same
> would be true for the silver oxides?  After all, aren't the oxides of
> silver even more soluble than is the chloride.

Silver oxide has a solubility of 0.0013 g/100 cc in cold water and 0.0053
g/100cc in hot water.

Silver peroxide is totally insoluble.

>
>
> I'm asking because the current, widely used practice is to satrurate
> ceramic purifiers with concentrated CS, which then goes through
> reactions in drying, ending up with the oxides.

I would be surprised if it ends up as an oxide, it is usually rather hard to
get silver to react with oxygen.  It should stay a metal if not exposed to
sulfur compounds, or nitrates.

> I guess what I'm asking
> is:  how could this be a problem for silver chloride and not for silver
> oxides?  And if a 'precendent' of sorts has been set, by allowing the
> oxides, why not the chloride?  Or is my chemistry off the mark?
>

I think you are off the mark.  But I did have a thought over the weekend.
Can you obtain copper power (or dust) very fine, like a flour, and mix that
in when you make them?  If so the you could run silver nitrate through
filter that has copper particles in it, and the silver will plate the
copper, as long as the copper does not become oxidized.. So you would end up
with copper particles, with a silver coating a few atoms thick on the
outside.  That would give you a lot of silver surface area, but with very
little silver being required overall.

Marshall

> Reid
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> Instructions for unsubscribing may be found at: http://silverlist.org
>
> To post, address your message to: [email protected]
>
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
>
> List maintainer: Mike Devour <[email protected]>