----- Original Message -----
Sent: Thursday, July 31, 2003 11:21
AM
Subject: RE: [smartBridges] Smartbridge
APPO max client associations?
35 should work matters if the RTS and frag are all tweaked or
are they all talking at the same time? The clients that is. I have about 28 on
my pop's and we had swore at one point not to go above 25 on our site hence
we're upgrading personally we don't use splitters its another point of failure
but it should work with the amp none the less. It really depends on use the
11mb RF is aggregate and shared so if everyones on or all the radios are
talking or evne the majority there going to go nuts.
Chris
-----Original Message-----
From: Eric
Helm [mailto:[EMAIL PROTECTED]]
Sent: Thursday, July 31, 2003 12:04 PM
To: [EMAIL PROTECTED]
What is the max client associations on an APPO without
comprimising the
performance of the throughput?
I have 1 APPO that has 35 clients on it, and 1 APPO that has
only 5
clients... the lesser of the two can get 2 Mbps
throuput, which is what we
are feeding it from the
backhaul, however on the APPO with 35 clients, the
max
throughput I can get is about 700 to 800 Kbps. The setup is as
follows:
1 APPO --> .5 Watt Amp --> Splitter
--> 2 - 120 degree sector antennas.
1 APPO --> 1
- 120 degree sector antenna
The APPO experiencing throughput problems it the one that has
the splitter
on it.. could this be causing the
problem? We just purchased the WISP that
setup the
APPOs and I am not opposed to adding a 3rd APPO if that would be a
viable solution, but I am concerned if 35 clients is going to
hinder the
performance that much.
Thanks,
Eric
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the
body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the
body type unsubscribe smartBridges)
Archives: http://archives.part-15.org
