Seeni, Actually, I have the frag level in AP hardware set to the higher number. But you are right on where I found the 2304. I wonder what it means, since it doesn't deal with Frag. Have a TAC opened with Cisco to find out. There manual doesn't clarify this issue.
Scott -----Original Message----- From: "Seeni Mohamed" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Date: Sat, 1 Nov 2003 16:19:55 +0800 Subject: RE: [smartBridges] Cisco/Smartbridges compatibility > Hi Scott, > > > > Normally, the default value specified in the smartbridges CPE units > will > match with the Cisco 350 settings. sB default fragmentation value is > 2346 which is compatible with any 802.11b complaint access points and > no > need to change these values unless if there is higher interference. > > > > This adjustment may be necessary if we deal with higher interference > then we need to lower down the values to improve efficiency in the > packet transmission which avoids the packet loss. > > > > I think you are referring to the Radio Identification settings, it > shows > the value of the maximum packet data length is 2304 and it can be > changeable from the "AP radio hardware" settings and you will find the > fragmentation threshold column to adjust the necessary values. > > > > Thank you > > > > Kind regards, > > Seeni > > sB Tech support > > > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of shoffman > Sent: Saturday, November 01, 2003 5:02 AM > To: [EMAIL PROTECTED]; [EMAIL PROTECTED]; [EMAIL PROTECTED] > Subject: [smartBridges] Cisco/Smartbridges compatibility > > > > Hi all, > > > > Sorry for the spam of the three lists, but they are all kind of > related. > > > > Was reading my nighttime book (Cisco 350AP Manual) to learn more about > > it. (Good sleeping material!). I cam across something interesting. > In > > > its config, a hard coded value of Packet size is set to 2304. > > Smartbridge CPE has Frag level by default at 2336 (or something like > > that)... Got me to thinking... Do these two values conflict? Do I > need > > to set all my smartbridge equipment to a Frag level of 2304? (or less) > > > > Scott > > > > The PART-15.ORG smartBridges Discussion List > > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> > > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > smartBridges) > > Archives: http://archives.part-15.org > > The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
