Pat,

 I just checked and it was .arc files that I was changing file (extension)
names on. After changing the file extension from .arc to .cor these pulled
up just fine in Compufoil, although my version is a later one than yours so
not sure if this would work. This also may not work with the .dat files but
I could have sworn I had some .dat files that I did this with also.


----- Original Message -----
From: "Pat McCleave" <[EMAIL PROTECTED]>
To: "RCSE" <[EMAIL PROTECTED]>
Sent: Saturday, March 16, 2002 10:45 PM
Subject: [RCSE] Converting .dat to .cor in Compufoil


> Hi Guys,
>
> A lot of you have suggested ways for me to use the .dat files in Compufoil
> but you have all just told me how to import them into the coords folder
and
> then bring them up.  That has not been a problem all along.  It is when I
> try to open the .dat file is when I get the error message (error detected
at
> coordinate #1-> 0.999841  -0.000170).  My version of Compufoil dates back
to
> Copyright 1992, 1993 so this may be part of the problem.  I may need to
> purchase Eric's most recent version in order to make these things work
> right.  Now, if anybody can tell me how to convert the files over to read
> like a .cor that would be great cause the .dat files I have right now are
> not working in my old version of Compufoil.
>
> See Ya,
>
> Pat McCleave
> Wichita, KS
>
> RCSE-List facilities provided by Model Airplane News.  Send "subscribe"
and "unsubscribe" requests to [EMAIL PROTECTED]

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to