Hi Francois,
I don't have success yet.
This is what I did:
1. modem_run -f /usr/local/libdata/mgmt.o
2. pppoa3 -b -e 1 -vpi 0 -vci 35 -v 1
3. ppp -background adsl
I attached ppp.log and ppp.conf (modified).
Thanks,
Nuno Teixeira
On Sat, Jul 12, 2003 at 11:41:57PM +0200, Francois Rogler wrote:
>
> On Sat, Jul 12, 2003 at 10:32:35PM +0000, Nuno Teixeira wrote:
> >
> > Hi Francois,
> >
> > I tested the first patch and this one on pppoa 1.2 beta 2 withous
> > success.
> >
> > I attached ppp.log and ppp.config to see if it helps.
> >
> > Thanks very much,
> >
> > Nuno Teixeira
> Hi
>
> Well the pb is that u r gona have to change the ppp.conf using the same
> config as other pppoe modems and say the network interface is tap0.
> And before launching the connection u have to launch pppoa3 in bridge
> mode (that will open the tap interface)
>
> --
> Francois Rogler
>
>
> Liste de diffusion modem ALCATEL SpeedTouch USB
> Pour se d?sinscrire : mailto:[EMAIL PROTECTED]
>
>
--
/*
PGP fingerprint:
C6D1 06ED EB54 A99C 6B14 6732 0A5D 810D 727D F6C6
*/
-- Attached file included as plaintext by Listar --
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: deflink: logout -> hangup
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: deflink: Disconnected!
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: deflink: Connect time: 4 secs: 0 octets in,
0 octets out
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: deflink: 0 packets in, 0 packets out
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: total 0 bytes/sec, peak 0 bytes/sec on Sat
Jul 12 23:16:03 2003
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: deflink: hangup -> closed
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: bundle: Dead
Jul 12 23:16:07 gw ppp[634]: tun0: Phase: PPP Terminated (normal).
Jul 12 23:16:07 gw ppp[634]: tun0: Chat: Parent notified of failure
Jul 12 23:16:07 gw ppp[633]: tun0: Phase: Parent: Child failed (errdead)
Jul 12 23:16:08 gw ppp[638]: Phase: Using interface: tun0
Jul 12 23:16:08 gw ppp[638]: Phase: deflink: Created in closed state
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set authname [EMAIL PROTECTED]
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set authkey ********
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set device PPPoE:tap0
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: accept chap
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set speed sync
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set timeout 0
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: enable lqr
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set lqrperiod 5
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set redial 15 10000
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set dial
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set login
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: set ifaddr 10.0.0.1/0 10.0.0.2/0
255.255.255.0 0.0.0.0
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: add default HISADDR
Jul 12 23:16:08 gw ppp[638]: tun0: Warning: Add route failed: 0.0.0.0/0 already exists
Jul 12 23:16:08 gw ppp[638]: tun0: Command: adsl: enable dns
Jul 12 23:16:08 gw ppp[639]: tun0: Phase: PPP Started (background mode).
Jul 12 23:16:08 gw ppp[639]: tun0: Phase: bundle: Establish
Jul 12 23:16:08 gw ppp[639]: tun0: Phase: deflink: closed -> opening
Jul 12 23:16:08 gw ppp[639]: tun0: Phase: deflink: Connected!
Jul 12 23:16:08 gw ppp[639]: tun0: Phase: deflink: opening -> dial
Jul 12 23:16:08 gw ppp[639]: tun0: Chat: deflink: Dial attempt 1 of 10000
Jul 12 23:16:08 gw ppp[639]: tun0: Phase: deflink: dial -> carrier
Jul 12 23:16:13 gw ppp[639]: tun0: Phase: deflink: Disconnected!
Jul 12 23:16:13 gw ppp[639]: tun0: Phase: deflink: carrier -> hangup
Jul 12 23:16:13 gw ppp[639]: tun0: Phase: deflink: Connect time: 5 secs: 0 octets in,
0 octets out
Jul 12 23:16:13 gw ppp[639]: tun0: Phase: deflink: 0 packets in, 0 packets out
Jul 12 23:16:13 gw ppp[639]: tun0: Phase: total 0 bytes/sec, peak 0 bytes/sec on Sat
Jul 12 23:16:08 2003
Jul 12 23:16:13 gw ppp[639]: tun0: Phase: deflink: hangup -> opening
Jul 12 23:16:13 gw ppp[639]: tun0: Phase: deflink: Enter pause (15) for redialing.
Jul 12 23:16:13 gw ppp[639]: tun0: Chat: Parent notified of redial
Jul 12 23:16:16 gw ppp[638]: tun0: Phase: Parent: Signal 2
Jul 12 23:16:16 gw ppp[639]: tun0: Phase: Caught signal 2, abort connection(s)
Jul 12 23:16:16 gw ppp[639]: tun0: Phase: deflink: Disconnected!
Jul 12 23:16:16 gw ppp[639]: tun0: Phase: deflink: opening -> closed
Jul 12 23:16:16 gw ppp[639]: tun0: Phase: bundle: Dead
Jul 12 23:16:16 gw ppp[639]: tun0: Phase: PPP Terminated (normal).
Jul 12 23:16:16 gw ppp[639]: tun0: Chat: Parent notified of failure
Jul 12 23:16:16 gw ppp[638]: tun0: Phase: Parent: Child failed (errdead)
-- Attached file included as plaintext by Listar --
#################################################################
# PPP Sample Configuration File to use with the Speedtouch USB
# Written by Francois Rogler <[EMAIL PROTECTED]>
#
# You will have to fill in :
# - <login>
# - <password>
# - <VPI>.<VCI> os defined by your provider. Common values are :
# - 8.35 or 8.67 in France
# - 0.38 in the UK
# - 8.48 in the Netherlands
# - 8.35 in the USA
# - 8.35 in Italy
#
# $Id: ppp.conf.sample,v 1.3 2001/08/14 21:15:19 rogler Exp $
#################################################################
default:
ident user-ppp VERSION (built COMPILATIONDATE)
set log Phase Chat IPCP CCP tun command
adsl:
set authname ********
set authkey *********
#set device !"/usr/local/sbin/pppoa3 -b -e 1 -vpi 0 -vci 35 -v 1"
set device PPPoE:tap0
accept chap
set speed sync
set timeout 0
enable lqr
set lqrperiod 5
set redial 15 10000
set dial ""
set login
set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.0 0.0.0.0
add default HISADDR
enable dns
Liste de diffusion modem ALCATEL SpeedTouch USB
Pour se d�sinscrire : mailto:[EMAIL PROTECTED]
