Roland,

Once again I find myself scratching my head and I hate to show my ignorance
but must ask a question.  If what you say is true, how can Figure
8.6.4.1.1.3 be accurate?  It sounds like 8.6.4.1.1.3 is a contradiction to
what you have stated below.  If what you say about soffit heads is correct,
I have laid out a lot of jobs incorrectly, which I hope is not the case but
would like to know now so I don't continue to make the same mistake in the
future.

Cliff Whitfield, SET
Fire Design, Inc

.-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Roland
Huggins
Sent: Thursday, April 03, 2008 10:28 AM
To: [email protected]
Subject: Re: sidewalls on the end wall

it will throw wider but the activation side must be accounted for.   
The wall that captures and turns the heat is the wall that it is  
installed in.  That wall is only 6 inches wide.  This is no different  
than installing a pendent sprinkler beneath a soffit.  IT is assigned  
the floor area directly beneath the soffit but NOT any of the floor  
beyond the soffit edge (although water will flow there).  AS stated  
in 8.6.4.1.1.1, the distance to the ceiling is measured throughout  
the assigned area of coverage (which is an activation issue).

Roland

On Apr 3, 2008, at 4:09 AM, Dewayne Martinez wrote:

> Roland, if I understand you correctly, because that head is  
> installed on
> a wall 6 inches wide wall it will only correctly throw a path 16ft  
> long
> by 6in wide (for 16'x16' sprinkler)? Why?
> Thanks,
> Dewayne
>
> -----Original Message-----
>
_______________________________________________
Sprinklerforum mailing list
[email protected]
http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum

To Unsubscribe, send an email to:[EMAIL PROTECTED]
(Put the word unsubscribe in the subject field)

_______________________________________________
Sprinklerforum mailing list
[email protected]
http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum

To Unsubscribe, send an email to:[EMAIL PROTECTED]
(Put the word unsubscribe in the subject field)

Reply via email to