The old Grinnell Fig. 258 is now an Anvil 258 and it is approved to a couple of Federal spec's and a couple of ANSI spec's.
David Autry Plans Examiner Nebraska State Fire Marshal's Office 246 S. 14th Street Lincoln, NE 68508 402-471-9659 402-471-3118 fax www.sfm.ne.gov ** Note new email address: [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Todd Williams Sent: Tuesday, August 04, 2009 3:40 PM To: [email protected] Subject: RE: pipe stands "9.2.6.2 Where pipe stands are utilized, they shall be approved" Tyco does not have anything listed on their web site. Steve, those are in part my questions. At 04:29 PM 8/4/2009, you wrote: >Approved by whom? Do you mean listed? > >Steve Leyton >Protection Design & Consulting >San Diego, CA > > > > >-----Original Message----- >From: [email protected] >[mailto:[email protected]] On Behalf Of >[email protected] >Sent: Tuesday, August 04, 2009 1:28 PM >To: [email protected] >Subject: Re: pipe stands > >I think Tyco sells approved stands > > >-----Original Message----- >From: Todd Williams <[email protected]> >To: [email protected] >Sent: Tue, Aug 4, 2009 4:25 pm >Subject: pipe stands > > > >NFPA 13 (2007) section 9.2.6.2 says that if pipe stands are used, >they must be approved. > >1. Are there any approved pipe stands? >2. Outside of the general comment on support of pipe, is there >anything specific on pipe stands in 2002? I couldn't find anything. >3. When calculating the weight of water-filled pipe for a riser >manifold, am I correct in assuming that the equipment and the >vertical piping would need to be considered? Has anyone actually done >this? > >Todd G. Williams, PE >Fire Protection Design/Consulting >Stonington, Connecticut >www.fpdc.com >860.535.2080 >_______________________________________________ >Sprinklerforum mailing list >http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum >For Technical Assistance, send an email to: >[email protected] > >To Unsubscribe, send an email >to:[email protected] >(Put the word unsubscribe in the subject field) > >_______________________________________________ >Sprinklerforum mailing list >http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum >For Technical Assistance, send an email to: >[email protected] > >To Unsubscribe, send an email >to:[email protected] >(Put the word unsubscribe in the subject field) > > >__________ Information from ESET NOD32 Antivirus, version of virus >signature database 4306 (20090804) __________ > >The message was checked by ESET NOD32 Antivirus. > >http://www.eset.com > > > >__________ Information from ESET NOD32 Antivirus, version of virus >signature database 4306 (20090804) __________ > >The message was checked by ESET NOD32 Antivirus. > >http://www.eset.com > >_______________________________________________ >Sprinklerforum mailing list >http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum >For Technical Assistance, send an email to: [email protected] > >To Unsubscribe, send an email to:[email protected] >(Put the word unsubscribe in the subject field) Todd G. Williams, PE Fire Protection Design/Consulting Stonington, Connecticut www.fpdc.com 860.535.2080 _______________________________________________ Sprinklerforum mailing list http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field)
