Right, so it may be at the city connection if there are no hydrants or interior hose.
George Church Rowe Sprinkler Systems, Inc. PO Box 407, Middleburg, PA 17842 877-324-ROWE 570-837-6335 fax [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Tuesday, February 22, 2011 9:22 AM To: [email protected] Subject: RE: Hose allowance The hose allowance is normally taken at the point of connection of any device that will use the water (hose connection,hydrant,etc.). Lamar Vaughn,SET On Tue, Feb 22, 2011 at 1:35 AM, [email protected] wrote: > Hi. > I remember that the hose allowance is added in the hydraulic > calculation in the node where the remote area ends over the cross > main. > Some people tell me that should be at the base of riser. We just > purchase AutoSpring and the software do this addition on the pump room > What is the way this should be? > Regards! > > > _______________________________________________ > Sprinklerforum mailing list > [email protected] > http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum > > For Technical Assistance, send an email to: [email protected] > > To Unsubscribe, send an email > to:[email protected] > (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field)
