And good luck making on a screwed fitting Todd G Williams, PE Fire Protection Design/Consulting Stonington, CT 860-535-2080 (ofc) 860-553-3553 (fax) 860-608-4559 (cell)
> > On Jul 21, 2017 at 3:33 PM, <Mark Phillips > (mailto:[email protected])> wrote: > > > > Plot pipe to full size Lay print on floor Hydraulic pipe bender to match > print PITA Sent from my Verizon 4G LTE Droid On Jul 21, 2017 3:31 PM, "Micah > Davis, SET" wrote: Anyone out there ever taken advantage of the allowance in > NFPA 13 to bend system piping? If so, how did you go about specifying it for > fabrication? Also, how did it turn out? Was it worth the effort? I have a > project that has a curved roof that looks almost like a wave. Bent pipe would > really help if I can figure out a way to get it fabricated. Micah Davis > www.dynamicfiredesigns.com _______________________________________________ > Sprinklerforum mailing list [email protected] > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org > >
_______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
